MS-183OR

SIZE 210*148MM

User Manual

Package contents

Wireless Optical Mouse

USB receiver

2 AAA alkaline batteries

User manual

Installing mouse process

Description of keys and DPI adjusting

Left key

Frontward key

Backward key

Right key

Scrolling wheel

DPI-adjusting key

Battery cover

ON/OFF switch

Position for storing receiver

(Diagram 2)

(Diagram 1)

Whenever new batteries are installed, make sure that they are fresh 1.5V

AAA batteries.

Installing the receiver (Diagram 1)

The codes of receiver and mouse were successfully connected in factory.

User can directly use the complete set of products, no worry about the code connecting.

A)Insert receiver into USB port of PC, the computer system will automatically detect it and prepare it for full operation.

B)Remove the battery cover.

C) Insert two AAA batteries into the battery compartment, make sure to properly orient the positive (+) and negative (-) ends as specified by the marks in the battery compartment. Replace the battery cover and make sure it is locked.

D)Switch on the mouse, the LED in bottom of mouse will blink red light.

E)The mouse may use then.

If the user wrongly operates, please redo the above operating procedures.

"ON/OFF" switch

Without using the mouse, user may turn off it by "ON/OFF" switch for saving battery power.

A)Using "DPI-adjusting key", the resolution of mouse can be switched between

800DPI and1600DPI in turn. That LED light in "DPI-adjusting key" blinks slowly indicates 800DPI and fast 1600DPI.

B)Backward and Frontward keys for your easily navigating forward and backward on the Internet

Low-voltage alarming function

When batteries have been used for some time and discover the LED light in

"DPI-adjusting key" blinks automatically, which reminds you that batteries' voltage is becoming low, suggested you replace the batteries with new ones.

System requirements

Windows 2000/XP/Vista/7

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) this device may not cause harmful interference, a n d ( 2 ) t h i s d e v i c e m u s t a c c e p t a n y i n t e r f e r e n c e r e c e i v e d , i n c l u d i n g interference that may cause undesired operation.

(1) 15.21 statement changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment.