KAIJET TECHNOLOGY INTERNATIONAL 2AD37JUE301 Wireless11N USB mini Adapter User Manual

Wireless 11N USB mini Adapter

� W indows Driver Installation

Please follow the steps below to install your new wireless network card:

1. Insert the device driver CD into the CDROM drive on your computer, double-click the Setup.exe

icon and run the

Setup.exe

program.

2. Select I accept the terms of the license agreement and then click Next .

5. Click Next ,the ready to install window will appear.

3. Select the setup type that best suits your needs, Install driver and Ralink WLAN Utility is recommended.

6. Click Install , and wait while the installation is in process.

4. Click Next , the Select Configuration Tool window will appear,you can manage this wireless adapter by either the Ralink Configuration

Configuration Tool .

Tool or the Microsoft Zero

7. Finally, click Finish to complete the driver installation.

� Connect to a Wireless Access Point

1. After installation has finished, it will automatically try to connect to any unencrypted wireless access point. If you want to connect to a specific wireless access point, or the access point you want to connect to uses encryption, you have to configure the wireless network card and input the correct password to connect to the wireless access point. To do this, double-click the icon.

2. The following window will appear:

4. Double-click the wireless access point’s SSID you want to use.If the access point is encrypted, you should follow the prompts to select the appropriate encryption type and enter your password.

3. Click the icon to scan available wireless access points.

Scan results will display in the Network zone. If you can ＇ t find the access point you want to connect to, click the button, until yourwireless access point is displayed. refresh

5. After you have connected to the wireless access point successfully, you can get detailed information on the connected access point such as status, IP address, speed, etc. Click the icon then the icon here you will see the signal quality and signal strength information.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC

Rules.

These limits are designed to provide reasonable protection against harmful interferece in a residential installation.

FCC Information and Copyright

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

15.19 Labelling requirements.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.

changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

FCC RF warning statement: the device has been evaluated to meet general RF exposure requirement , The device can be used in portable exposure condition without restriction.