1
Tabs
Fuser removal and replacement
Use the following procedure to remove the fuser.
74
1
Unplug the power cable.
2
Remove the paper delivery tray assembly (RM1–1859–000CN).
Chapter 5
Removal and replacement
ENWW
3
Remove two (2) screws from the right cover assembly (RM1–1858–000CN).
1
ENWW
Two (2) screws
4
Remove the right cover assembly, carefully disengaging the catches.
5
Unplug the control panel cable.
Removal and replacement procedures
75
76
6
Insert a screwdriver to loosen the release tab on each side of the upper face cover.
7
Remove the upper face cover (RC1–5174–000CN).
8
Remove four (4) screws from the upper cover (RC1–5176–000CN).
Chapter 5
Removal and replacement
ENWW
9
Lift up and remove the face-down cover (RC1–5173–000CN).
10 Remove the output tray by releasing the tabs.
1
Release tabs
11 Unplug the harness from the fuser motor.
ENWW
Removal and replacement procedures
77
12 Open two (2) clips and remove one (1) clip to remove the fuser connector.
78
1
Open clips
2
Remove clip
1
Fuser connector
2
Remove clip from the board by pulling up
Chapter 5
Removal and replacement
ENWW
13 Unplug two (2) 3-pin optical encoder wires.
14 Unplug the red high-voltage bias wire.
15 Remove the thermistor wire.
ENWW
Removal and replacement procedures
79
16 Remove the cables from the wiring harness.
17 Remove three (3) screws from the fuser chassis.
1
Three (3) screws
18 Gently rocking if necessary, roll the fuser (RM1–1820–00CN for 110V) or (RM1–1821–000CB for
220V) forward to remove.
80
Chapter 5
Removal and replacement
ENWW
Use the following procedure to replace the fuser.
1
Align the fuser tabs with their respective holes.
2
Complete replacement by following steps 1 through 18 above in reverse order.
NOTE When replacing the right cover, align the tabs on the upper edge of the right cover
and lower edge of the face-down cover with their respective slots.
1
Tabs
NOTE Connect the control panel cable before replacing the right cover.
ENWW
Removal and replacement procedures
81
Formatter removal and replacement
Use the following procedure to remove the formatter.
82
1
Remove the cassette dust cover (RC1–5200–000CN).
2
Remove nine (9) screws from the rear plate (RC1–5227–000CN).
Chapter 5
Removal and replacement
ENWW
">
