M808BT

Instruction Manual

Micro USB

Charging Port

LED Indicator

Volume Up / Previous Track

Multifuctional Button

Volume Down / Next Track

** Please read all instructions prior to using the device.

Bluetooth Power ON/OFF:

1. Power on : Press and hold the multi-function button for 3 seconds until the LED flashes blue 3 times.

2. Power off : Press and hold the multi-function button for 3 seconds to power off.

3. If the LED Indicator turns from BLUE to RED when in standby mode, turn the device off to conserve

power.

4. Bluetooth Pairing:

A. Press and hold the multi-function button for 6 seconds. The LED Indicator will flash BLUE & RED

indicating pairing mode.

B. Activate the Bluetooth function on your mobile device and select “BUZZ” to pair. Mobile device will

indicate when pairing has been successful.

Answering Calls :

Short press the multi-function button to answer an incomming call.

Ring off the call:

Short press the multi-function button to hang up an active call.

Call back:

Short press the multi-function button 2 times to redial the last active caller’s number.

Charging:

• Insert the Micro-USB plug into the charging port and connect the opposite USB end to a computer

or compatible ACwall adapter.

• LED Indicator will light up in RED while charging. LED will become BLUE when battery is full.

Volume Control

• Short press the “+”button to increase volume;

• Short press the “-” button to reduce volume;

Select Previous/Next Track:

• Press and hold the “+” button to select the previous track.

• Press and hold the “-” button to select the next track.

MADE IN CHINA

FCC Information and Copyright

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

15.19 Labelling requirements.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation. changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

FCC RF warning statement: the device has been evaluated to meet general RF exposure requirement , The device can be used in portable exposure condition without restriction.