8
FCC Notice
Class B digital device
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against the device creating harmful interference in a residential installation.
This device generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this device does cause harmful interference to radio or television reception, which can be determined by turning the device off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna
– Increase the separation between the device and receiver
– Connect the device to an outlet on a circuit different from that to which the receiver is connected
– Contact AudienceCare for help
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the device.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC Radio Frequency Interference Requirements
This device contains a wireless adapter that, when operating in the frequency range 5.15 to 5.25 GHz, remains indoors to reduce the potential for harmful interference to co-channel Mobile
Satellite systems. High power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands. These radar stations can cause interference with and/or damage the wireless adapter installed.
Note: The combined radiated output power of the wireless modules installed is far below the FCC radio frequency exposure limits. Nevertheless, this device should be used in such a manner that the potential for human contact during normal operation is minimized. To avoid the possibility of exceeding the FCC radio frequency exposure limits, you should keep a distance of at least
8 inches (20 centimeters) between you (or any other person in the vicinity) and the antenna that is built into this device.
Details of the authorized configurations can be found at http://www.fcc.gov/oet/ea/ by entering the FCC ID numbers on the device.
Questions? Contact AudienceCare at (855) 662-8388
9
