Date First Used
Calibration Log
Recalibration Date Notes
AlcoHAWK® PT500 Quick Guide
BREATH PIPE IN
DISPLAY
BREATH OUT
DO NOT COVER
WHILE TESTING
ON/OFF POWER BUTTON
ENTER BUTTON
SELECT BUTTON
Operating Instructions
Wait 20 minutes after the test subject smokes, eats or drinks before testing. Failure to wait 20 minutes can give inaccurate BAC readings and damage the sensor.
Step 1) Press and hold the ON/OFF power button for 1 second until you hear a BEEP. The unit reads “Initializing...” as it prepares for use.
Step 2) The screen displays “Test” and “Options”. To start a “Test”, press the ENTER button . The unit displays “Blow Now”.
Take a deep breath, wrap your lips around the new mouthpiece and blow steadily for five (5) seconds.
The unit beeps when the test subject starts blowing and beeps again after obtaining the sample. Do not cover the BRE ATH OUT hole.
Step 3) The unit displays “Processing” while analyzing the sample.
After about three (3) seconds, the unit then displays the estimated BAC.
Step 4) The unit shows the test result for 90 seconds before beeping twice and shutting off.
Step 5) To turn off the unit, press and hold the ON/OFF power button
for 1 second.
To toggle through available menu options, press the SELECT button. See manual for details on the menu options.
THIS DEVICE IS INTENDED TO MEASURE ALCOHOL IN THE HUMAN BREATH.
DO NOT DRINK AND DRIVE.
SEE OWNER’S MANUAL FOR RE-CALIBRATION INSTRUCTIONS THAT MUST BE ROUTINELY PERFORMED.
