MOMENT 200-002 Bluetooth Remote User Manual

Bluetooth remote control operation manual

1: Flip the switch to ON to start the device. First, the fast broadcast light flashes for 8s, and then the slow broadcast light flashes for 1 second.

Then, turn ON the bluetooth of the mobile phone to search for the bluetooth device name"Mosment Remote", and match it. When the

Bluetooth connection is successful, and the LED indicator is off.

2: Click the "take photo" button to take photos. Press the "take photo" button to flash the LED indicator once.

3: If bluetooth is not paired or paired, bluetooth remote control will automatically enter deep sleep in 5 minutes, press the button to broadcast again.

4: toggle switch to OFF.

5: Bluetooth remote control has memory, automatic connection function.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be u sed in portable exposure condition without restriction

FCC ID:

2AEZQ-200-002