iGear IG1920 Earphone and Headset User Manual

IG1920 User Manual

Congratulations on your new iGear.com.au product.

Please read the following instructions prior to use.

This is a Bluetooth device; initial pairing is required.

PAIRING

1.

Ensure your device’s Bluetooth mode is switched on.

2.

Plug in your new Bluetooth earphones.

3.

From available detected devices select “iGear-IG1920” and pair.

4.

After your new earphones are connected, you will hear an audible sound.

5.

Once pairing is successful you will be able to listen to music and make and receive phone calls using your new earphones.

6.

Once you have paired your new earphones for the first time they will pair automatically when next used. If unpaired manually or the Bluetooth connection is lost simply repeat the above steps.

BUTTON CONTROL

MUSIC MODE-

Short Press Multifunction Button (MFB): Play/Pause.

Double Short Press MFB: Next track.

Triple Short Press MFB: Previous track.

PHONE MODE-

Short Press MFB: Answer/Hang up call.

Press and hold MFB for 2 seconds: Reject call.

VOLUME CONTROL-

Short Press +: Volume is increased by one level each time.

Short Press -: Volume is decreased by one level each time.

TROUBLE SHOOTING

If pairing is unsuccessful, please try the following:

1.

Ensure that the earphones are plug into your device properly, some protective cases can restrict access to the charging port.

2.

Ensure Bluetooth mode on your device is switched on.

3.

If your new earphones are not detected by your device simply try switching your Bluetooth mode off and then on again.