Installation Instructions

INSTALLATION

INSTRUCTIONS

PARTS LIST

(2)

Accessory

ACCESSORY SOCKET

P/N 08E70-MJG-670

(3)

(1)

Qty

1

1

1

Application

GL1800B

Publication No.

MII 14360

Issue Date

December 2012

INSTALLATION

NOTE:

• Disconnect the negative (-) cable from the battery before installing this accessory.

• After turning the ignition switch OFF, wait more than

10 seconds and then remove the negative (-) battery cable.

• The memories of the tripmeter and clock will be erased when you disconnect the battery. Reset the clock after reconnecting the battery.

• Reinstall the removed parts on the motorcycle and make sure that the wires and harnesses are not pinched.

• Trim the excess ends off the wire ties after attaching them to the wire harnesses. Do not allow the cut part of the wire tie to interfere with another harness or brake hose.

1. Open the left saddlebag lid as shown.

No.

(1)

(2)

(3)

Description

Installation Instruction URL

Accessory socket

Wire tie

SUPPLIES REQUIRED

Electric drill

Holesaw (30 mm)

Side cutters

Marker

Ruler

File

TORQUE CHART

Refer to the Service Manual for the torque values of the removed parts.

LEFT SADDLEBAG LID

2. Remove the left side cover, and disconnect the negative (-) cable from the battery.

© 2012 Honda Motor Co., Ltd. - All Rights Reserved.

1 of 3

LEFT SIDE COVER

87946-MJG-6701

3. Remove the left cowl trim mould as shown.

LEFT COWL

TRIM MOULD

5. Drill at the marked point of the left front pocket as shown.

• Remove any burrs from the edge of the hole.

LEFT FRONT POCKET

4. Remove the left front pocket as shown.

CLIP

LEFT FRONT

POCKET

ELECTRIC DRILL

(30 mm HOLESAW)

MARK

Using a file, remove the from the left front pocket.

FILE

part

5 mm

3 mm

2 of 3

6. Route the accessory socket harness from the inside of the pocket and secure it with the nut as shown.

8. Secure the accessory socket harness with the wire tie as shown.

ACCESSORY

SOCKET

WIRE TIE

Secure the accessory socket harness to the motorcycle’s harness.

LEFT FRONT POCKET NUT

Remove from the accessory socket before passing through the hole.

ACCESSORY

SOCKET

HARNESS

FUSE

ACCESSORY

SOCKET

HARNESS

7. Connect the accessory socket harness as shown.

LEFT FRONT POCKET

ACCESSORY

SOCKET HARNESS

9. Install the motorcycle’s parts in reverse order of the removal.

• Confirm that any wire harness is not caught or too tight.

3-PIN CONNECTOR (Red)

After connecting, store the connector in the harness boot.

HARNESS BOOT

3 of 3