Operation:
Product:
Recharging the USB Charger:
The CPP 50 can be recharged by connecting it to a USB port.
When connecting to a USB port connect the USB input from
the CPP 50 to the standard USB port on a computer, a USB wall
charger, or any 5V USB charging port.
USB Charger
The CPP 50 comes with an integrated cable for recharging. When
recharging the CPP 50 via USB the indicator light bar will show
the current battery life according to the chart below. The light bar will
blink to show that the CPP 50 is charging. When the CPP 50 is fully
charged the light bar will stop blinking.
Portable Power – Anytime Anywhere!
Thank you for purchasing the Cobra CPP 50 USB Charger.
Before using this product, please read these instructions
carefully to learn about the features and capabilities of the
charger and how you can get the best out of it.
Note: Please charge your CPP 50 USB Charger completely
prior to using it for the first time.
Charging a device:
To charge a device, connect the device to the CPP 50 USB
output and press the power button on the CPP 50. The light bar
will turn green to show that the device is charging. The CPP 50 has an
integrated USB connector to charge devices that have a micro USB input
without needing a separate cable. Simply plug in the micro USB
connector to the device and pres the power button on the CPP 50.
The light bar will turn green to show that the device is charging.
The CPP 50 can charge three devices at a time with any combination
of the integrated micro USB output and the two full size USB outputs.
When charging multiple devices the charging rate may be slower than
when charging a single device depending on the devices being charged.
Note: For the rapid charge 5V/2.1A output: In order to charge at the
fastest rate you should charge only one device at a time.
(USB wall adapter
not included)
5V/2.1A USB output
5V/1A USB output
Charging with your USB cables:
Power/capacity
switch
Product Features:
FCC Statement:
• 5,000mAh Li-polymer rechargeable battery
• Integrated USB cables can charge micro USB devices and recharge
the CPP 50 without any cables
• Fully charge most smartphones three times. Charge an iPad over 70%
• 5V/2.1A USB output for rapid charging of an iPhone, iPad, & other
fast charge devices
• Three outputs allow for charging of multiple devices at the same time
Product Specification:
• Li-polymer
rechargeable battery:
3.7V/5,000mAh
• USB input:
5V/1A
• Size:
2.51” x 4.25” x 0.65” (64mm x 108mm x 16.5mm)
• Weight:
4.9 oz. (140g)
• Recharging time:
15 hrs by 5V/0.5A USB
8 hrs by 5V/1A USB
• Power/Capacity button: Press to start charging or to check the
battery capacity
• Capacity display:
The light bar indicators show the
battery capacity
Warnings and Cautions:
• Do not puncture, throw, drop, bend, disassemble, or attempt to repair
your CPP 50.
Check Battery Capacity:
To check the remaining battery capacity of the CPP 50 press the
power/capacity button on the front of the unit with no devices
connected. The top of the CPP 50 has an indicator light bar to show
the remaining battery capacity:
1 Segment on: 10%-40% charge
2 Segments on: 40%-65% charge
3 Segments on: 65%-85% charge
4 Segments on: 85%-100% charge
Model: CPP
COBRA LASER DETECTORS
50
5V/1A USB input
5V/1A Micro USB output
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/television technician
for help.
Indication light bar
USER MANUAL
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
Note: When charging a device the number of lit segments may decrease
while you are charging a rapid charge device like a smartphone or
tablet or when charging multiple devices. The battery capacity
indicators cannot accurately measure the capacity during rapid
charging. To confirm the real battery capacity disconnect the device(s)
being charged and press the power/capacity button.
WARNING: Any modifications made to this device that are not
expressly approved by party responsible for compliance could void
the user’s authority to operate this device.
• Keep your CPP 50 dry and away from moisture and corrosive materials.
Charging with integrated Micro cable:
• Do not wash your CPP 50 with chemicals or soaps. Instead wipe the
top and bottom with a soft, water dampened cloth. Wipe the inputs and
outputs with gently with a soft dry cloth.
• Fully recharge your CPP 50 once every 3 months when not in use.
Charge the CPP 50 SP fully prior to putting it away for extended storage.
• Do not expose the unit to fire or excessive heat.
• Do not short-circuit the connectors with any metal objects.
• Do not transport or store the unit with metal objects that may
short-circuit the connectors.
• Avoid static electricity, strong magnetic fields and radiation.
• Stop using the unit if it generates an unusual smell, is excessively hot,
is deformed, or demonstrating any other abnormalities.
PROPOSITION 65 WARNING: This product contains a chemical
known to the State of California to cause cancer and birth defects
or other reproductive harm.
• Never throw away electronic devices in the garbage.
Recycle according to local recycling and environmental regulations.
GPS RADAR DETECTOR
">
