Ganz WML-1 Manual

GANZ
Security Solutions
MAM
e
INSTALLATION MANUAL - WML-1 Dome Camera Wall Mount
Unpacking
Unpack carefully. This is mechanical equipment and
should be handled with care. If an item appears to
have been damaged in shipment, replace it properly
in its carton and notify the shipper. If any items are
missing, notify CBC America Inc. (CBC). The shipping
carton is the safest container in which the unit may
be transported. Save it for possible future use.
Service
If the unit ever needs repair service, the customer
should contact CBC for a return materials
authorization (RMA) and shipping instructions.
Care and Maintenance
Perform routine maintenance to keep the unit dust
free.
Model Designation
WML-1 Wall Mount for Dome Cameras
Description
The wall mount is used to attach the camera to a
wall. The kit contains an optional gasket for reducing
water ingress into the mount through the cable hole.
When installed outdoors, this mount should only be
used with outdoor rated dome cameras.
Hardware Kit
4 x Wall Anchor Bolts
4 x Wall Anchors
2 x M4 x 12mm Phillips Screws
2 x M4 Washer
2 X M4 Nut
1 x Gasket
Tools Required
e #2 Phillips Head Screwdriver
e #3 Phillips Head Screwdriver
e Appropriate drill for wall anchors
e 7mm or 8/32 Wrench or Nut Driver
Certification
Camera installations should be performed by a
licensed professional and conform to the National
Electrical Code (NEC) and any applicable local codes.
Installation
1. Remove the WML-1 from its packaging.
2. Remove the mount plate by loosening the four
screws shown in Figure 1.
Figure 1 - WML-1 Mount Plate
3. Attach camera to mount plate (see Figure 1)
using the M4 fasteners provided in the hardware
kit. Tighten using a #2 Phillips head screwdriver
and 7mm (or 8/32”) wrench or nut driver.
4. Feed the camera cable through the cable hole in
the rear of the mount (see Figure 2) before
reattaching the mount plate.
Cable notch Ny
Cable hole
Mounting
holes (4)
Figure 2 - WML-1 Rear
Page 1 of 2
GANZ
Security Solutions
If installing the mount outdoors, ensure the
camera is rated for outdoor use. Locate the
gasket from the hardware kit. Remove the
adhesive from the gasket. Install the gasket,
with the slit facing down, around the camera
cable as shown in Figure 3.
Install gasket
with slit facing
down
Figure 3 - Secure gasket around cable
Route the camera cable through the cable notch
(see Figure 2) or drill an appropriate sized hole
through the mounting surface for the camera
cable.
7.
10.
Hold the mount up to the installation surface
and use the mounting holes (see Figure 2) as a
template to mark the mounting surface.
Select appropriate fasteners depending on the
type of installation surface. The anchors
provided may not be ideal for all installations.
Ensure that the fasteners selected have at
minimum 100lbs pull-out strength.
Drill out the mounting surface to an appropriate
depth for the fasteners used and install the
anchors. If using the anchors from the hardware
kit, the diameter of these fasteners is 80.300”
(7.5mm).
Align the mounting holes with the anchors.
Ensure the camera cable is positioned properly
before installing the anchor screws using a #3
Phillips head screwdriver.
Page 2 of 2