Blossom LED M3 R24 Installation Manual

LED M3 R24/LED M3 R32

LED M3 R24/LED M3 R32

LED M3 R24/LED M3 R32

Electrical Drill 1/8” Drill Bit Pencil

Phillips

Screwdriver

Tape Measure Level

SCREW

(x2)

WALL PLUG

(x2)

LED M3 R24/LED M3 R32

WIRE CONNECTOR

(x2)

LED M3 R24/LED M3 R32

Live / Black

Neutral to white

Live to black

Ground to green.

Field Wire

Ground / Green

Neutral / White

LED M3 R24/LED M3 R32

• 5mm copper free silver mirror

• High output LED lighting:

CRI 90+, 2700-6400K CCT, IP44

• Colour changing and dimmable touch switch for surface LED

• Vertical and horizontal mount options

• Defogger

PLACEMENT

Select the desired position of the mirror.

Mark the curve at the top of the mirror.

TOP

A

SUPPORT LOCATION

Measure the center of the holes and mark the drilling locations ensure marking are leveled.

A

B

A

BOTTOM

INSTALL SCREWS screw and the wall.

B

B

A

PLACEMENT

Place the mirror against the wall and slide down as shown in image B.

A

B

B

C

LED M3 R24/LED M3 R32

2 - 3mm

Touch to turn the task light and defogger on or off.

Press and hold to change the colour temprature of task light.

Press and hold to dim or brighten the task light.

[email protected]

Please visit our website for more information.

www.BlossomUS.com