OUTSHINE LOT Orange 2AZGU OrangeLink Pro User Guide

Orange Getting Started Guide

1.) Press the small button on the front of the OrangeLink to open the battery lid.

2.) Insert (2) 1.5v DC AAA Batteries into the OrangeLink, see below for ( - ) and ( + ) orientation, and close the lid.

3.) Enable the OrangeLink in your Loop Application:

Settings > Pump > Devices - Orange (enable toggle switch ON)

4.) To RESET the OrangeLink. Open the battery lid and then close it again.

LED and Haptic (Vibration) Feedback Indications

1. When OrangeLink is first powered on, LED light will blink Red and Yellow with a strong vibration.

2. When OrangeLink is powered on but not connected to a phone the LED light will blink Red every 10 seconds

3.

When OrangeLink is first connected to a mobile phone, a SOFT vibration is triggered.

4. When the OrangeLink is connected to a mobile phone, LED light will blink Yellow every 10 seconds

5.

When OrangeLink is disconnected from a mobile phone a STRONG vibration is triggered.

6.

When battery is low, LED light will be constant RED, and with SOFT vibration every 2 mins.

7. When the OrangeLink has a "super low" battery, the voltage is too low to trigger constant RED and

SOFT vibration, you will see the OrangeLink repeatedly (connect then disconnect) from the phone (See below for Super Low Indication)

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.