- Home
- Do-It-Yourself tools
- Power tools
- Paint Sprayer
- Graco
- 309284A Radiator Tip Extension Kit for HVLP Guns
- Owner's manual
advertisement
Installation Instructions
INSTRUCTIONS
For detailed HVLP–Turbine Gun information and warnings see Operating Instructions manual 309317.
Radiator Tip Extension Kit for
HVLP–Turbine Guns
Radiator Tip Extension 244138
WARNING
Relieve all fluid pressure in the system before you install, remove, or replace any parts. See the
Pressure Relief Procedure below or for more information refer to Operating Instructions manual
309317.
Form No. 309284
Rev. A
This manual contains kit installation instructions only.
To find your local Graco authorized service center
D Call us at 1–800–690–2894
D Visit our website at www.graco.com
A
A
Pressure Relief
Procedure
1. Turn off turbine and air supply to gun.
2. Unlatch cup
OR
3. Open pressure relief (A) on pot until pressure is completely relieved. Close relief.
GRACO INC.
P.O. BOX 1441 MINNEAPOLIS, MN 55440–1441
E COPYRIGHT 2001, GRACO INC.
Graco Inc. is registered to I.S. EN ISO 9001
Radiator Tip Extension Kit
WARNING
Relieve all fluid pressure in the system before you install, remove, or replace any parts. See the
Pressure Relief Procedure below or for more information refer to Operating Instructions manual
309317.
5
1
2
D
3
C
B
4
A
1.
Turn off air supply to gun.
2.
Relieve pressure following the Pressure Relief
Procedure provided on the front of this instruction sheet or in manual 309317.
3.
Using your hand, remove air cap retaining ring (A) and air cap housing.
4.
While triggering the gun, use your hand to remove nozzle.
5.
Using your hand, remove fluid knob assembly (B) and compression spring (C) from back of gun.
Remove needle.
6.
Attach fluid nozzle (2) to front of gun.
7.
Slide air tube (4) over fluid nozzle (2).
8.
Slide air cap retaining ring (A) over air tube until it meets the threaded end of gun (D). Hand tighten.
9.
Insert needle (1) in back of gun and guide it into fluid nozzle (2).
10. Replace compression spring (C) and fluid knob assembly (B). Hand tighten.
Parts
1
2
3
4
5
244179
244182
116571
244181
113137
NEEDLE
NOZZLE, fluid
CLIP, nozzle
TUBE, air
O–RING
All written and visual data contained in this document reflects the latest product information available at the time of publication.
Graco reserves the right to make changes at any time without notice.
GRACO INC.
P.O. BOX 1441 MINNEAPOLIS, MN 55440–1441 www.graco.com
PRINTED IN USA 309284 March 2001
2 309284
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project