Invacare Flo-tech Evo Back Backrest User Manual

Flo-tech Evo Back
Fitting Instructions
INSTRUCTIONS FOR ASSEMBLY – MOUNTING BLOCKS
Installing the Mounting Blocks:
Figure 25
1. Dismantle the assembled blocks and
remove the Shell Spacers.
2. Assemble and install. In most cases the
pre-assembled mounting block will be
suitable without the spacers.
Occasionally it may be necessary to use
the additional spacers to suit different
cane diameters, as shown in Figures
25
Please note: Mounting Blocks are normally
installed to the rear of the canes and angled
inwards to align with the wheelchair arms.
They can also be mounted in front of the canes
but if so ensure the Clamping Screws remain
accessible for the final adjustment and
tightening.
20mm (3/4”)
TUBES USE
CLAMP BANDS
WITH THICK
SPACERS
22mm (5/8”)
TUBES USE
CLAMP BANDS
WITH THIN
SPACERS
25mm (1”) TUBES
USE CLAMP
BANDS
NO SPACERS
9 8
Figure 26
WARRANTY
The Flo-tech Evo Backs are covered by a warranty period of 24 months.
Manufactured for Invacare Ltd by Performance Health Products Limited.
Invacare Ltd
Pencoed Technology Park
Pencoed, Bridgend CF35 5HZ, UK
Tel: +44 (0) 1656 776222 Fax: +44 (0) 1656 776220
E-mail: [email protected] Web: www.invacare.com
Part Number - 1539017
This product is
manufactured to comply
with the Medical Device
Directive
8
V1.4 - 10th September 2010
">