GLG LIGHTING EQUIPMENT

Technical SPECIFICATION:

Model No:

Voltage Input ：

LED Type:

Beam Angle:

Optical Lens Size:

Protocol:

DMX Channel Mode:

Control Mode:

Dimmer Mode:

PWM Dimming:

Battery Powered:

Wireless DMX:

Body Material:

Waterproof Grade:

Product Size

Net Weight.:

GLG Creator Basic Battery DLX

100-240V AC, 50/60Hz

TianXin 6in1 LEDs

25°

42mm

USITT DMX-512, AirDMX System

3/6/8/11 CH

AirDMX, DMX-512, Standalone, Master/slave, Sound

Active, iOS or Android Smartphone

4 Dimming Curves

16bit PWM Dimming at 5200HZ

14.8V x 8.8Ah = 131Wh

2.4G Wireless DMX Transceiver

Aluminum Die-casting

IP33 Indoor Use Only

138x144x188mm

3Kgs

Creator Basic Battery DLX

User Manual

Getting Started

What’s In The Box?

• 1 x Creator Basic Battery DLX: battery powered wireless LED Uplights

• 1 x Powercon schuko cable, powercon link cable, this User Manual [email protected] www.goedlichtengeluid.nl 1

Getting It Out Of The Box

Congratulations on purchasing one of the brightest, best-built led uplights anywhere! Now that you’ve got your Creator Basic Battery DLX , you should carefully unpack the box and check the contents to ensure that all parts are present and in good condition. If anything looks as if it has been damaged in transit, notify the shipper immediately and keep the packing material for inspection. Again, please save the carton and all packing materials. If a fixture must be returned to the factory, it is important that the fixture be returned in the original factory box and packing.

Powering Up!

All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0% to 100% switch.

AC Voltage Switch - Not all fixtures have a voltage select switch, so please verify that the fixture you receive is suitable for your local power supply. See the label on the fixture or refer to the fixture’s specifications chart for more information. A fixture’s listed current rating is its average current draw under normal conditions. Check the fixture or device carefully to make sure that if a voltage selection switch exists that it is set to the correct line voltage you will use.

The Lithium Battery System

The Creator Basic Battery DLX features our proprietary Lithium-Ion internal battery system which allows the user to operate their light without AC power for up to 20 hours.

It is powered with Lithium Battery of 14.8V 8.8Ah=131Wh

When you get the Creator Basic Battery DLX at the first time, please install the

2.5A fuse into the fuse holder on the light , which you can find in the carton box. As for www.goedlichtengeluid.nl 2 air or sea shipping safety, all battery powered fixture need designed to be off and can not been turned on at any time during shipping.

Turn on the power switch on the The Creator Basic Battery DLX you can find the approximate percentage of power remaining from the TFT Screen as below:

BATT: 50% TEMP: 36C

To charge the battery simply plugs the light into a power source. The battery will charge weather the light is powered on or off. It will charge even while in use. The built-in microprocessor of the battery system controls the charge and overall battery health, so all you need to do is plug and play. From the TFT Screen you can see the approximate percentage of power remaining. When after 3 hours charging, you can find the

BATT: 100% TEMP: 36C

IMPORTANT:

Please ask the professional engineer to repair if there is any quality question, or send back to the factory, please do not repair by yourself.

The “Wireless DMX System”

1. The “Wifi dmx” includes one “ WifiDMX Box” , and “wifiDMX RECV” on each Light, you can connect the “WifiDMX Box” to DMX Controller.

2. For each “WifiDMX Box” and “WifiDMX RECV” , there is 7 ID, each ID match one led light color from

Red, Green, Yellow, Blue, Violet, Cyan, White; that means you can set up 7 groups of Wireless

Transceiver System for different lights in the same Place, and each wireless transceiver system will not disturb others.

3. Press the “ID Setting” button on the “WifiDMX Box” and “WifiDMX RECV” both to select your desired operating group [email protected]

GLG LIGHTING EQUIPMENT

4. The 7-Color Status LED will change color to indicate the current ID group: You can scan the QR code on the “WifiDMX Box” to download the right app for your smart phone

· GROUP 1: RED 1. iOS Android OS

· GROUP 2: GREEN

· GROUP 3: YELLOW

· GROUP 4: BLUE

· GROUP 5: VIOLET

· GROUP 6: CYAN

· GROUP 7: WHITE

5. The status LED on the ”AirDMX Box” will flash RED until data is transmitted from the DMX

Controller or Smartphone App

6. The status LED on the ”AirDMX RECV” will flash GREEN until communication is established with the. ”AirDMX Box”

2. After installation of the app, turn on the power switch on the “WifiDMX Box” , please connect your smart phone to the wifi named as “AirDMX001-xxx”. The Wifi password is “ 12345678 ”

3. Open the “AirDMX Wifi” app:

The “DMX Wifi” App for iOS or Android

www.goedlichtengeluid.nl 3 [email protected]

2. Standard Mode

www.goedlichtengeluid.nl

8 Channel

Ch1

Ch2

Ch3

Ch4

Ch5

Ch6

Ch7

Ch8

2. Easy Mode

Ch1

Ch2

6 Channel

Ch3

Ch4

Ch5

Ch6

3. HSV Mode

3 Channel

Ch1

Ch2

Ch3

000-255

000-255

000-255

000-255

000-255

000-255

000-255

000-255

000-255

The Channel Modes

000-255

000-255

000-255

000-255

000-255

000-255

000-255

000-255

Master Dimmer

Red

Green

Blue

Amber

White

UV

Strobe

Red

Green

Blue

Amber

White

UV

Hue

Saturation

Value

4 [email protected]

GLG LIGHTING EQUIPMENT

1. Extend Mode :

11 Channel

Ch1

Ch2

Ch3

Ch4

Ch5

Ch6

Ch7

Ch8

Ch9

Ch10

Ch11

000-255

000-255

000-255

000-255

000-255

000-255

000-255

000-255

000-015

016-095

096-175

176-255

0-255

000-005

006-065

066-125

126-185

186-255

Master Dimmer

Red

Green

Blue

Amber

White

UV

Strobe

None

Auto Mode

Fade Mode

Sound Active

Speed for Ch9

Menu Default

Linear Dimmer Mode

Curve Dimmer Mode

Theatre Dimmer Mode

Studio Dimmer Mode

• Please keep this User Guide for future use. If you sell the unit to someone else, be sure that they also receive this User Guide.

• ALWAYS make sure that you are connecting to the proper voltage, and that the line voltage you are connecting to is not higher than that stated on the decal or rear panel of the fixture

• This product is intended for indoor use only.

• To prevent risk of fi re or shock, do not expose fixture to rain or moisture.

• Make sure there are no flammable materials close to the unit while operating.

• The unit must be installed in a location with adequate ventilation, at least 20in (50cm) from adjacent surfaces. Be sure that no ventilation slots are blocked.

• ALWAYS disconnect from the power source before servicing or replacing fuse and be sure to replace with same fuse size and type.

• ALWAYS secure fixture using a safety chain. NEVER carry the fixture by its cord. Use its carrying handles.

• DO NOT operate at ambient temperatures higher than 104°F (40°C).

• In the event of a serious operating problem, stop using the unit immediately; NEVER try to repair the unit by yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please contact the nearest authorized technical assistance center.

Always use the same type spare parts.

• NEVER connect the device to a dimmer pack.

• Make sure the power cord is never crimped or damaged.

• Never disconnect the power cord by pulling or tugging on the cord.

• Avoid direct eye exposure to the light source while it is on.

Caution! There are no user serviceable parts inside the unit. Do not open the housing or attempt any repairs yourself. In the unlikely event your unit may require service, please contact GLG (Goed licht en geluid).

The Safety Instructions

The Menu Panel

www.goedlichtengeluid.nl 5 [email protected]

The Control Panel

There are 4 control buttons below the LED display which allow you to navigate through the various control panel menus.

<ESC> Is used to navigate to the previous higher-level menu item.

<DOWN> Scrolls through the menu items and numbers in descending order.

<UP> Scrolls through the menu items and numbers in ascending order.

<ENTER> Is used to select and confirm/store the current selection

Address : 001-512

Channel : 6 / 8 / 11 / 3

Slave : Master / Slave

Auto : 1-15

Fade : 1-15

Color : 1-31

Sound : 1-10

Red : 000

Green : 000

Blue : 000

Amber : 000

White : 000

UV : 000

Strobe : 00

Dimmer : 1-4

Screen : ON / 30”s

BATT : 100% TEMP : 36C *

The Menu Structure

www.goedlichtengeluid.nl

Address Setting

4 Channel Modes

Slave/Master

Auto Chase

Auto Fade

Preset Colors

Sound Active Mode

Red Dimmer

Green Dimmer

Blue Dimmer

Amber Dimmer

White Dimmer

UV Dimmer

Strobe

4 Dimming Curves

Screen on or off

When screen is off, just click the

“ESC” button to turn off the screen save mode

Battery / Temperature / DMX

6 [email protected]