Smart Safe
Catalogue No. S 2 E
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS FOR SAFE & ELECTRONIC
CONTROL PANEL
IMPORTANT:
Please keep your keys in a secure place, but not in the safe.
Keep your personal code secure.
Do not use personal data (eg: birthdays, telephone numbers etc).
HOW TO OPEN THE SAFE WITH THE KEY:
Carefully remove the cover plate that is located next to the keypad.
Insert the key and turn it anti-clockwise until it stops. Then turn the knob clockwise and open the door.
HOW TO INSTALL THE BATTERIES:
Remove the plastic cover from the box located on the inside of the safe door.
Insert 4 x AA Batteries, 1.5 V (Alkaline).
HOW TO PROGRAM YOUR PERSONAL CODE:
Open the door.
Press and release the RED button on the inner side of the door jamb.
Enter your personal code. (3 - 6 digits).
Press the # key to store your new code.
HOW TO OPEN THE SAFE USING THE KEYPAD:
Enter your personal code (3 – 6 digits).
Press the # key.
After the melody you can open the door with the knob (turning clockwise).
HOW TO CLOSE THE SAFE:
Close the door and turn the knob anti-clockwise.
BATTERY INDICATOR:
The batteries should be replaced immediately if the RED light comes on.
After having replaced the batteries the personal code must be re-programmed.
ALARM IN CASE OF WRONG CODE:
After the third incorrect code the opening mechanism is blocked for 2 minutes.
After this time has elapsed the safe can be opened with the correct code.
INSTALLATION:
The safe can be installed by securing to a wall or the floor with the masonry bolts provided.
