BatteryMINDer 12248-A-ODY Battery Charger INSTRUCTION MANUAL

BatteryMINDer©
Model 12248-A-ODY
DC CONNECTION PRECAUTIONS
a. Connect and disconnect DC output clips from battery only
after removing charger power cord from outlet.
b. Attach clips to battery posts and twist or rock back and
forth several times to make good contact. This tends to keep
clips from slipping off terminals and reduces risk of sparking.
FOLLOW THESE INSTRUCTIONS WHEN BATTERY
IS INSTALLED IN EQUIPMENT (VEHICLE, PWC,
BOAT, TRACTOR, ETC.) A SPARK NEAR BATTERY
MAY CAUSE BATTERY TO EXPLODE. TO REDUCE
RISK OF A SPARK NEAR BATTERY:
c. Position DC output cord to reduce risk of damage by hood,
door, covers, or moving engine parts.
d. Stay clear of fan blades, belts, pulleys, and other parts that
can cause injuries.
e. Check polarity of battery posts. POSITIVE (POS, P,+) usually
has a larger diameter than NEGATIVE -.
f. Determine which post of battery is grounded (connected)
to the chassis of equipment. If negative post is grounded see
Item N. If positive post is grounded see item P.
N. For negative grounded equipment, connect POSITIVE
(RED) clip from charger to POSITIVE (POS, P, +) ungrounded
post of battery. Connect NEGATIVE (BLACK) clip to vehicle
chassis or engine block away from battery. Do not connect clip
to carburetor, fuel lines, or metal body parts.
g. For positive ground equipment, connect NEGATIVE
(BLACK) clip from charger to NEGATIVE (NEG, N,)
UNGROUNDED POST OF BATTERY. Connect POSITIVE
(RED) CLIP to chassis or engine block away from battery.
Rev. D-050509
Page P/N VDC12248-A-ODY-MNL
">