DELUXE SERIES 3-ROW 15' BLEACHER
MODEL LAPN203-15 3-ROW 15' ALUMINUM W/O GUARDRAILS (240 LBS)
SHOWN ASSEMBLED
(Shipped disassembled)
Specifications:
Bleacher Frames, Horizontal and diagonal Bracing:
Fabricated from 2" x 2" x 3/16" steel or aluminum angle. Frames are welded into a single unit. (Frames may have optional 2" x 6" ground sills at every point where frames are in contact with the ground.)
Deluxe Series bleachers conform to the requirements of ICC 300-2012.
Seat and Foot Planks: Nominal 2" x 12" x 15' extruded ribbed aluminum. The tops of planks shall be ribbed. The ribbed pattern, non-slip surface, is designed for safety and comfort. All exposed ends shall have aluminum caps fastened to the underside of the plank. Planks secure to each frame with two friction-type aluminum mounting clips capable of securing plank against movement under a horizontal force of 400 lbs. (all hardware is provided.)
Finish: All fasteners shall be zinc plated.
Date:
Rev:
03-05-10
Drawn:
SS8211 7
AMC
DELUXE SERIES 3-ROW 15' BLEACHER
MODEL NO.
1183-315
Sheet:
1 of 3
6"
INSTALLATION INSTRUCTIONS:
1. Check materials received with the parts list (Page 3) to make sure that all components are included and to assure that the unit is complete.
2. Installing End Caps on seat and foot planks: a. Locate (5) 2" x 12" x 15' seat and foot planks and (10) 2" x 12" end caps. b.Align and assemble all end caps to aluminum planks. Secure using a #10 x 3/4" self-tapping screw in two locations on the underside of the clip/plank. See End Cap Detail.
3. Locate three bleacher frames and set on a level surface on 74" centers. See Detail below.
4. To Install Cross Braces: a. Locate two sets of diagonal braces measuring 2" x 2" x 77-1/2". See Frame Detail.
Install on the backside of the 3rd seat upright, using the top and bottom holes in the frame. Repeat steps to assemble second and third sets of cross braces to the other bleacher frames. b. On the center bleacher frame at the top and bottom brace attachment locations where two diagonal braces attach at the same installation point, secure braces using 3/8" x 1-1/4" hex bolt, washers and lock nut provided. See Detail. c. At the center point of the cross braces secure brace connection using 3/8" x 1" hex bolt, washer and locknut provided. See Detail. d. At all installation points install washers and nuts but leave hardware loose until assembly is complete for easy installation.
Note: Two washers are provided to use at every hex bolt location. See Detail.
5. To install seat planks: a. First install the plank clips using 5/16" x 1" carriage bolts, washer and lock nuts, on top of seat and foot board supports. Give nuts about 3/4 turn (just enough to secure). Turn plank clips perpendicular to the frames. See Detail. b. Position seat planks on the seat supports so the plank clips are between the slots in the bottom of planks. See Detail. c. Reach up underneath the seat & foot planks and turn the plank clips to the position shown. See Typical Cross Section Detail.
6. To install foot planks: a. Follow the steps as outlined in step 5 for installation of foot planks.
7. To Secure Planks to Frames: a. Align the end of the planks on rows 1-3 so they are approximately 15" from outside edge of plank to center of eacher frame. Tighten all hardware on frames & planks securely.
8. Cut and peen all exposed bolt threads past 2 threads out of nut.
Note: To insure proper installation, bolts used to secure seat, foot and riser planks must be tightened until the clips are firmly in contact with the plank. See Typical Cross Section.
9. Installing (Optional) Ground sills (wood measuring 2" x 6" x 4'-6"): a. Center one ground sill under each bleacher frame so the ends are evenly spaced and are centered from side to side. Mark the (2) hole locations in each bleacher frame on each of the ground sills and drill 1/4" x 1" deep pilot holes. Do Not drill completely through the ground sills. b. Attach the ground sills to the bottom of the bleacher frames with 5/16" x 1-1/4" lag bolts and flat washers provided.
15"±
15 3/4"
11 1/2"
180"
23 3/4"±
6" 12"
74" 74"
Date:
Rev:
Drawn:
Sheet:
03-05-10
SS82117
AMC
DELUXE SERIES 3-ROW 15' BLEACHER
MODEL NO.
1183-315
2 of 3
Cross
Braces
3/8" x 1"
Hex Bolt
BLEACHER
FRAME
CROSS
BRACES (77-1/2")
For Cross Braces
Use 3/8"x1"
Hex Bolts here on exterior Frames & Ctr for Cross Braces
Use 3/8"x1-1/4"
Hex Bolts here on
Ctr Frame
1.70
PLANK PATTERN
5/16" x 1"
Carriage Bolt
11.46
Plank
Clip
2.95
End
Cap
5/16" Flat Washer
Self
Tapping
Screw
5/16" Hex Nut 5/16" x 1"
Carriage Bolts for
Seat/Foot Planks
SEAT/FOOT
PLANK DETAIL
3 ROW BLEACHER
HARDWARE
DELUXE
3/8" x 1" Hex Bolt
3/8" x 1-1/4" Hex Bolt
DELUXE 3 ROW BLEACHER
3/8" Lock Nut- Nylock
3/8" Flat Washers
5/16" x 1" Carriage Bolt
5/16" Lock Nut - Nylock
5/16" Flat Washers
#10 x 3/ 4" Self Tapping Screw
2" x 12" End Caps
Alum. Plank Clips
PACKING SLIP
15' 3-Row
3-Frames
QTY
Aluminum Plank Anodi zed 3
Aluminum Plank Mill Finish 2
3 Row Bleacher Frames
Diagonal Frame Brace 77-1/2"
Optional Ground Sills (54")
DESCRIPTI ON
3
4
3
QTY
Cross Brace Ctr & on Exterior Frames
Cross Braces on Ctr/Interior Frames
6
2
Seat & Foot Planks to Bleacher Frames
8
16
30
End Cap Mounting
End Caps on Alum. Planks
Mounting Plank Clips
30
30
20
10
30
Optional Ground Sills
5/16" x 1-1/4" Lag Screws
5/16" Flat Washers
Ground Sills to Bleacher Frames 9
9
Date:
Rev:
Drawn:
Sheet:
03-05-10
SS82117
AMC
DELUXE SERIES 3-ROW 15' BLEACHER
MODEL NO.
1183-315
3 of 3
Pick Ticket
Internal use only return to office with packet
Shipping to pull Frames, Plank, and Hardware Below nothing required from Fabrication.
3 ROW BLEACHER
HARDWARE
DELUXE
3/8" x 1" Hex Bolt
3/8" x 1-1/4" Hex Bolt
DELUXE 3 ROW BLEACHER
3/8" Lock Nut- Nylock
3/8" Flat Washers
5/16" x 1" Carriage Bolt
5/16" Lock Nut - Nylock
5/16" Flat Washers
#10 x 3/ 4" Self Tapping Screw
2" x 12" End Caps
Alum. Plank Clips
PACKING SLIP
15' 3-Row
3-Frames
QTY
Aluminum Plank Anodi zed
Aluminum Plank Mill Finish 2
3 Row Bleacher Frames
Diagonal Frame Brace 77-1/2"
Optional Ground Sills (54")
3
3
4
3
DESCRIPTI ON
QTY
Cross Brace Ctr & on Exterior Frames
Cross Braces on Ctr/Interior Frames
6
2
8
Seat & Foot Planks to Bleacher Frames
16
30
30
30
End Cap Mounting
End Caps on Alum. Planks
Mounting Plank Clips
20
10
30
Optional Ground Sills
5/16" x 1-1/4" Lag Screws
5/16" Flat Washers
Ground Sills to Bleacher Frames 9
9
If Shipping is running low on braces or frames please inform office as soon as possible.
