Flightcom VENTURE V90SP Operation Manual

MAINTENANCE

Care and Maintenance

• Inspect ear seals and mic muff frequently for wear. Replace at 6 month intervals.

If you see any defect such as holes or cracks in the ear domes, ear seals, or headband, headset should be immediately repaired or replaced.

• Do not remove the foam speaker cover.

• To ensure proper function, keep the microphone away from excessive moisture.

Do not store headset in high temperature environments or direct sunlight.

• Wipe headset and ear seals with a mild soap and water mixture only. The foam mic muff may be removed and cleaned in a mild detergent, or replaced by ordering from Flightcom.

WARNING

Never immerse any part of the Headset in water.

GENERAL AVIATION HEADSETS

Operation Manual

V90SP/MPH V70SP

To Order Flightcom Accessories:

Call: 1-800-432-4342

Flightcom Corporation

1 7 600 SW 65th Ave , Lake Oswego , OR 97 035 USA

800-432-4342 • [email protected] • flightcom.net

Copyright © Flightcom Corporation 2019.

All rights reserved.

Flightcom is a registered trademark of Flightcom Corporation.

Specifications subject to change without notice.

600-3039-00 Rev C

V50SP/MPH

General Aviation

V30SP

INSTALLATION

Insert the larger plug into the jack marked “headphone” or “phone”.

• Insert the smaller plug into the jack marked “microphone” or “mic”.

• Set the stereo/mono switch on the cable splitter box to the “M” position.

If connecting to a stereo intercom, set the switch to the “S” position.

• Adjust headband slider and mic boom for proper fit and comfort.

• Place the microphone no more than 1/8” from lips, at the corner of the mouth.

This is critical to the performance of the noise canceling electret microphone.

• Two independent volume controls are provided, one on each ear dome, to adjust the level of audio. (Single volume on V30SP)

If the aircraft does not have a built-in push-to-talk (PTT) switch, a portable PTT switch must be installed in order to use the radio. The master gain control located in the aircraft radio should be optimized by an avionics technician whenever adding a new model microphone to the system.

HEADSET ADJUSTMENTS

Adjustable headband

Volume control

Adjustable

Boom

Mic Placement

Place mic no more than 1/8" from lips. Placement of mic is critical for proper operation.

WARNING

If the microphone is positioned incorrectly, you may experience a reduction or interruption in the audio and or deterioration in clarity of intercom and radio.

Model Domes Ear Seals Head Band Pad Head Band Color Boom

V90SP Carbon Fiber ComLeather

V90MPH 1 Thick

Wide w/polar fleece

Chrome

Headset Bag

Precision Flex Heavy Fabric

V70SP Carbon Fiber ComLeather Low-profile w/polar fleece

Air pillow

Black

Black

Precision Flex

Precision Flex

Fabric

Vinyl V50SP Glossy Black PVC Open

V50MPH 1 Cell Foam

V30SP Black PVC Open

Cell Foam

1 Helicopter headset: uses U174 plug

Ventilated

Low-profile

Black Precision Flex None

HEADSET FEATURES

• Passive Noise Reduction by 24dB

• Stereo/Mono switchable

• Noise-canceling electret microphone

• Adjustable Headband

• Flexible mic boom with slide adjustment for accurate mic positioning

SPECIFICATIONS

TECHNICAL SPEC

- Weight ...............................................17.1oz Avg. (w/o Comm Cable)

- Noise Reduction Rating .........................................................24dB

MICROPHONE

- DC Bias Supply ..................................8 to 16 volts, not polarity sensitive

- Source Resistance ................................................220 to 2200 ohms

MIL SPEC

- Humidity & Temperature per MIL-STD 810F and 810G

- Chemical Exposure per MIL-STD 810F and 810G

SAE

- Salt Spray per J1455, Sec. 4.3

WIRING DIAGRAM

Caution:

Bias voltage supplied to the microphone must come from voltage and resistance ranges specified above.

Voltages supplied in excess of those stated in the specifications can cause microphone failure and void warranty. The mic audio signal is present between the ring and barrel of the mic plug; tip is reserved for transmit keyline.

Right

Speakers

Left

Mic.

(Single volume on V30SP)

Right

Speakers

Left

Mic.

Helicopter

M

6.3 mm Plug

S

5.2 mm Plug

4 Conductor Plug

INSTALLATION

Insert the larger plug into the jack marked “headphone” or “phone”.

• Insert the smaller plug into the jack marked “microphone” or “mic”.

• Set the stereo/mono switch on the cable splitter box to the “M” position.

If connecting to a stereo intercom, set the switch to the “S” position.

• Adjust headband slider and mic boom for proper fit and comfort.

• Place the microphone no more than 1/8” from lips, at the corner of the mouth.

This is critical to the performance of the noise canceling electret microphone.

• Two independent volume controls are provided, one on each ear dome, to adjust the level of audio. (Single volume on V30SP)

If the aircraft does not have a built-in push-to-talk (PTT) switch, a portable PTT switch must be installed in order to use the radio. The master gain control located in the aircraft radio should be optimized by an avionics technician whenever adding a new model microphone to the system.

HEADSET ADJUSTMENTS

Adjustable headband

Volume control

Adjustable

Boom

Mic Placement

Place mic no more than 1/8" from lips. Placement of mic is critical for proper operation.

WARNING

If the microphone is positioned incorrectly, you may experience a reduction or interruption in the audio and or deterioration in clarity of intercom and radio.

Model Domes Ear Seals Head Band Pad Head Band Color Boom

V90SP Carbon Fiber ComLeather

V90MPH 1 Thick

Wide w/polar fleece

Chrome

Headset Bag

Precision Flex Heavy Fabric

V70SP Carbon Fiber ComLeather Low-profile w/polar fleece

Air pillow

Black

Black

Precision Flex

Precision Flex

Fabric

Vinyl V50SP Glossy Black PVC Open

V50MPH 1 Cell Foam

V30SP Black PVC Open

Cell Foam

1 Helicopter headset: uses U174 plug

Ventilated

Low-profile

Black Precision Flex None

HEADSET FEATURES

• Passive Noise Reduction by 24dB

• Stereo/Mono switchable

• Noise-canceling electret microphone

• Adjustable Headband

• Flexible mic boom with slide adjustment for accurate mic positioning

SPECIFICATIONS

TECHNICAL SPEC

- Weight ...............................................17.1oz Avg. (w/o Comm Cable)

- Noise Reduction Rating .........................................................24dB

MICROPHONE

- DC Bias Supply ..................................8 to 16 volts, not polarity sensitive

- Source Resistance ................................................220 to 2200 ohms

MIL SPEC

- Humidity & Temperature per MIL-STD 810F and 810G

- Chemical Exposure per MIL-STD 810F and 810G

SAE

- Salt Spray per J1455, Sec. 4.3

WIRING DIAGRAM

Caution:

Bias voltage supplied to the microphone must come from voltage and resistance ranges specified above.

Voltages supplied in excess of those stated in the specifications can cause microphone failure and void warranty. The mic audio signal is present between the ring and barrel of the mic plug; tip is reserved for transmit keyline.

Right

Speakers

Left

Mic.

(Single volume on V30SP)

Right

Speakers

Left

Mic.

Helicopter

M

6.3 mm Plug

S

5.2 mm Plug

4 Conductor Plug

MAINTENANCE

Care and Maintenance

• Inspect ear seals and mic muff frequently for wear. Replace at 6 month intervals.

If you see any defect such as holes or cracks in the ear domes, ear seals, or headband, headset should be immediately repaired or replaced.

• Do not remove the foam speaker cover.

• To ensure proper function, keep the microphone away from excessive moisture.

Do not store headset in high temperature environments or direct sunlight.

• Wipe headset and ear seals with a mild soap and water mixture only. The foam mic muff may be removed and cleaned in a mild detergent, or replaced by ordering from Flightcom.

WARNING

Never immerse any part of the Headset in water.

GENERAL AVIATION HEADSETS

Operation Manual

V90SP/MPH V70SP

To Order Flightcom Accessories:

Call: 1-800-432-4342

Flightcom Corporation

1 7 600 SW 65th Ave , Lake Oswego , OR 97 035 USA

800-432-4342 • [email protected] • flightcom.net

Copyright © Flightcom Corporation 2019.

All rights reserved.

Flightcom is a registered trademark of Flightcom Corporation.

Specifications subject to change without notice.

600-3039-00 Rev C

V50SP/MPH

General Aviation

V30SP