You will fi nd the addresses and phone numbers of the service organisation on the guarantee card.
3LIK1224
Operating instructions
CC4520
EN
Manual EN 3 - EN 14
Pictograms used
Important information
Tip
CONTENTS
Your canopy hood
Safety
Precautions you must take 5
Extraction 6
Use
Maintenance
Installation
Appendix
EN 3
EN 4
YOUR CANOPY HOOD
Description
Introduction
A Lighting
C Fan position 1
D Fan position 2
E Fan position 3
F Timer
This user manual gives you a quick overview of all the possibilities offered by the appliance. You will find information on safety measures and maintaining the appliance.
Please retain this user manual and the installation guide.
They may be of use to future users of the appliance.
SAFETY
Precautions you must take
Make sure the appliance is installed by an authorised installer
(see "Installation" chapter). Do not connect the appliance to the mains before completing the installation.
• Connect the appliance in accordance with the applicable regulations in your area. of the cooker hood because of possible sharp edges.
safety standards. However we do advise that persons with a mental or motor impairment do not use this appliance without the proper supervision of a competent person. The same applies to children.
installed!
• Never place objects on the hood unless specifically indicated.
hood on a gas cooker.
other heating appliances.
promptly. Never leave frying pans unattended during use, as the heated fat may catch fire.
month) on the inside as well as on the outside. Insufficient cleaning or late replacement of filters may pose a fire hazard.
by the manufacturer’s service department or by a person with equivalent qualifications, in order to prevent dangerous situations from arising.
• Attention! Intensive use may cause condensation to form on the cooker hood. Condensation can be removed easily with a dry cloth.
EN 5
SAFETY
Precautions you must take
EN 6
Extraction systems
mains! Only use identical lamps with the wattage indicated. Only use the cooker hood with lamps installed, in order to reduce the risk of electric shock.
appliances.
• The grease filters become hot during operation. Wait a minimum of
30 minutes after cooking before cleaning the filters.
• The power must be switched off during repairs or cleaning. Remove the plug from the mains socket or turn the switch in the meter cupboard to zero.
vicinity of the cooker when preparing food.
appliance, or fires resulting from non-observance of the instructions included in this manual.
Depending on the type, the cooker hoods can be connected in one of two ways:
1. To a duct.
The cooking vapours extracted by suction are carried outside, once the grease particles have been filtered. This is the best method.
2. Recirculation hood. When the hood is connected as a recirculation hood, the grease particles and odour in the extracted vapours are filtered.
The extracted air is not carried outside but recirculates in the kitchen. In this case you must have a carbon filter fitted.
Attention! The carbon filter needs to be ordered separately.
USE
Controls
Switching fan on and off
Press the speed button C, D or E
The extractor hood switches on in the corresponding position.
Press the off button B.
The fan will switch off.
Switching lighting on and off
Press the lighting button A.
The lighting switches on.
Press the lighting button A again.
The lighting switches off.
Timer
Press the F button
The timer is switched on. The extractor hood remains switched on in this setting for 15 minutes. After that, the extractor hood switches off.
Press the F button again.
The timer is switched off.
EN 7
EN 8
MAINTENANCE
Cleaning
Attention! Before performing any maintenance operation, isolate the hood from the electrical supply by unplugging the appliance or switching off your household’s master switch. The cooker hood should be cleaned regularly (at least as frequently as the grease filters are cleaned) both internally and externally. Do not use abrasive products.
Do not use alcohol!
Attention! Failure to comply with the basic recommendations for cleaning the cooker hood and cleaning/replacing the filters may lead to a fire. Therefore, we recommend that you observe these instructions.
The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations.
Cooker hood
Clean the cooker hood with soapy water and a soft cloth. Then wipe with clean water to rinse. Do not apply aggressive cleaning agents such as caustic soda. The paintwork on the cooker hood will remain shiny if it is periodically rubbed with wax.
Stainless steel canopy hoods
Do not use any sort of scourer. Treat with a stainless steel care product and polish with the structure of the stainless steel.
Metal grease filters
These must be cleaned once a month (or when indicated by the filter saturation indication system, if present on your model) using nonaggressive detergents, either by hand or in the dishwasher, which must be set to a low temperature and a short cycle. The openings must be placed downwards to let the water run out of the filters. When washed in a dishwasher, aluminium grease filters may be discoloured slightly.
This is normal and does not affect their filtering capacity.
MAINTENANCE
Grease filters
Removing the grease filters
• Move lock ‘C’ in a downward direction and remove filter ‘G’ from the hood.
Carbon filter
Lighting
Replacing the carbon filter
The carbon filter must always be used if the cooker hood is not ducted.
1. Remove the grease filters ‘G’.
2. Attach the carbon filters ‘J’ by hooking the brackets ‘K’ in the openings.
3. Replace the grease filters ‘G’.
Note:
prolonged use, depending on the type of cooking and how frequently the grease filter is cleaned.
• The carbon filter cannot be washed for reuse. Saturated carbon is not environmentally friendly. Change the filter regularly.
Changing the light bulbs
• Remove the lamp cover.
• Replace the halogen light bulb with a replacement bulb with a maximum output power of 20 Watts.
EN 9
EN 10
INSTALLATION
General
This appliance must be connected to the electric mains by an authorised installer who is familiar with the safety precautions and will carry them out. The appliance is in compliance with European guidelines.
Important information:
hob must be at least 65 cm.
other appliance must be connected to the duct (such as a hot water heater or a stove).
appliances.
cooker hood will work.
present.
We recommend that the exhaust pipe has as large a diameter as possible.
concrete and brick walls. For some types of wall you may need special plugs and screws.
INSTALLATION
Connection
Electric connection
The appliance has been manufactured as a class II, therefore no earth cable is necessary.
Make sure the supply voltage ratings correspond with those stated on the appliance data plate. The connection to the mains is carried out as follows:
BROWN = phase L
BLUE = phase N
This canopy hood has been provided with a power plug. When installing the hood, make sure that this plug remains accessible. We recommend installing the wall socket out of view, behind the chimney cover.
Attention!
If you are making a fixed connection, you must ensure that a double pole switch with an air gap of at least 3 mm is fitted in the supply line.
max 90 cm
EN 11
INSTALLATION
Building in dimensions
EN 12
Assembly
• Remove the grease filters.
• Make an opening underneath one of the kitchen cupboards. Check the dimensions on the installation drawing.
• Screw the hood into the kitchen cabinet with 4 screws.
APPENDIX
Disposal
Disposal of appliance and packaging
This appliance was manufactured using sustainable materials. It must be disposed of responsibly at the end of its life cycle. The local authorities can provide you with the relevant information.
The packaging of this appliance is recyclable. It may have been made from:
• polythene film (PE);
• CFRP-free polystyrene (PS hard foam).
You need to dispose of these materials responsibly in accordance with official regulations.
To draw attention to the fact that the segregated processing of household electrical appliances is compulsory, this appliance carries the symbol of a crossed-out dustbin. This means that you may not dispose of the appliance as household refuse at the end of its useful life. Instead, it should be taken to a special segregated refuse collection centre run by the local authority or to a dealer providing this service.
Segregated processing of household appliances prevents any negative impact on the environment and public health that might otherwise arise. It allows the recovery of the materials used to manufacture this appliance, thus generating considerable savings in terms of raw materials and energy.
Declaration of conformity
We declare that our products meet the applicable European Directives,
Decisions and Regulations and the requirements listed in the standards referenced.
EN 13
EN 14
