Mount-It! MI-789 Mount-It Full Motion Triple Monitor Desk Stand User guide

Installation Instruction

English

UNPACKING INSTRUCTIONS

!

Carefully open the carton, remove contents and lay out on cardboard or other

protective surface to avoid damage.

!

Check package contents against the Supplied Parts List in the next page to assure

that all components were received undamaged. Do not use damaged or defective

parts.

!

Carefully read all instructions before attempting installation.

IMPORTANT SAFETY INFORMATION

!

Install and operate this device with care. Please read this instruction before installation, and carefully follow all instructions contained herein. Use proper safety equipment during installation.

!

Please call a qualified installation contractor for help if you don't understand these directions or have any doubts about the safety of the installation.

Do not use this product for any purpose or in any configuration not explicitly specified in this instruction. We hereby disclaims any and all liability for injury or damage arising from incorrect assembly, incorrect mounting, or incorrect use of this product.

1

Supplied Par ts List

(1) 48mm Pole-a (1) Weighted Base-b (1) Monitor Arm-c (1) Plastic Cover-d

(1)M10 Bolt-e (1)Support Plate-f (1)M10 Washer-g (1)Spring Washer-h

(2)M8x10 Bolt-i (3)M6x29 Bolt-j (1)Allen Key-k (1)Wrench-l

(12)M4x12 Bolt-m (12)M4x30 Bolt-n

Tools Required

(12)M4 Space-o (2)Spare Cover-p

Phillips Screwdriver

CAUTION!

!

This monitor desktop mount must be securely installed to the horizontal desk. If the mount is not properly installed it may fall, resulting in

WARNING possible injury and/or damage.

2

Step 1 Mounting the base according to your requirement

The stand can be used with the weighted metal base or there is a desk attachment provided (as drawings on the bottom) allowing you to mount the stand on a desk.

This is very simple to install and just requires a hole drilling (10mm diameter) in your desk and clamping with the bolt and large washer. a

Option 1 d j b

Option 2 Option 3 a d a d j b h g f e h g e f

3

Step 2 Install Monitor Arm to the Pole

Install monitor arm to the pole, please make sure the wire clip in the downside. Fasten the

M8x10 bolt(i) by screw driver.

c i

Wire Clip

Step 3 Mount the Monitor to VESA Plate m o n

For Flat Back Monitor

4

For Curved Back Monitor

Step 4 Do the Necessary Adjustment k l

Use the Allen Key(k) to adjust the turning tension. Use the Wrench(l) to tighten the nut if the tilt angle can not be fixed.

Loosen the bottom bolt and fasten the top bolt to lower the center monitor. Reversely, if you want to rise the center monitor.

Step 6 Manage the Wires

Thanks for choosing our products, enjoy the using.

5