Meat Grinders

Models:

177MG12, 177MG22

03/2020

Please read and keep these instructions. Indoor use only.

www.AvantcoEquipment.com 1

User Manual

Index

Warnings and Cleaning Instructions

���������������������������������������������������� 3

Parts Diagram �������������������������������������������������������������������������������������� 4

Parts Key ��������������������������������������������������������������������������������������������� 5

Limited Replacement Warranty ����������������������������������������������������������� 6

2 www.AvantcoEquipment.com

User Manual

General Safety Warnings

NEVER operate Grinder without the Tray secured in place.

To avoid serious or fatal injury, NEVER reach into any Grinder inlet.

ALWAYS use the Stomper to push meat into the Grinder Head.

ALWAYS disconnect the Grinder from the power source before any disassembly for cleaning or any other reason.

1.

2.

3.

4.

5.

6.

7.

8.

9.

10.

11.

ALWAYS disconnect the Grinder from power source or outlet before any cleaning/maintenance.

Plug the Grinder into a standard 120 Volt, 60 Hz wall outlet.

DO NOT USE the Grinder if the Power Cord, Plug or any other parts are damaged.

Do not allow the Power Cord to drape into your work area.

NEVER use any accessories or parts from other manufacturers. Doing so will VOID YOUR

WARRANTY and may cause fire, electrical shock or injury.

DO NOT SUBMERGE THE GRINDER MOTOR INTO LIQUID OR WATER. BE SURE THE GRINDER

IS DISCONNECTED FROM THE POWER SOURCE BEFORE CLEANING.

KEEP FINGERS CLEAR of the Auger and Cutting Blades AT ALL TIMES. NEVER REACH INTO THE

GRINDER, doing so may cause serious injury. ALWAYS USE THE PROVIDED STOMPER, NEVER

FEED FOOD BY HAND.

NEVER use fingers to scrape food away from the Grinding Plate while the Grinder is in operation.

SEVERE INJURY MAY RESULT.

NEVER OPERATE THE GRINDER UNATTENDED.

Tie back loose hair and clothing, and roll up long sleeves before operating the Grinder. REMOVE ties, rings, watches, bracelets, or other jewelry before operating the Grinder.

SAVE THESE INSTRUCTIONS

1.

2.

3.

CLEANING INSTRUCTIONS

4.

5.

6.

7.

8.

See above warnings and ensure the unit is removed from the power source.

Separate the head from the body using the thumbscrew located on top of the body.

Remove the tray and unscrew the front guard. The grinding plate, auger and knife may now be removed.

Wash all parts that have come in contact with meat in hot soapy water. Cleaning should be done immediately after use. DO NOT immerse the motor body in water.

Rinse the Grinder parts with clean hot water, then dry them using a cloth. DO NOT place them in the dishwasher.

Fully lubricate the Head, Plates and the Knife with a food grade silicone spray before and after each use.

Clean the Motor Cover and Gear Housing with a damp towel and wipe dry. quickly.

Make sure the grinder and all components are completely dry before assembling or storing.

www.AvantcoEquipment.com 3

User Manual

SAUSAGE STUFFING ASSEMBLY

1.

2.

Be sure the grinder is unplugged.

3.

4.

5.

SAUSAGE STUFFING DIRECTIONS

• It is recommended that 2 people perform sausage stuffing.

• Do not operate the grinder without meat in the grinder head.

Damage to auger and/or motor can occur.

1.

2.

•

•

• Slide the stuffing plate onto auger. The grinding blade is not used when stuffing.

•

Be sure the grinder is unplugged.

Attach grinder head to motor and install auger as previously described in General Assembly instructions.

(See Fig. A)

Slide one of the stuffing tubes through the funnel flange and place in the grinder ring cap

(stuffing tube faces out). The stuffing tube size used depends on the type of casing you have chosen to use.(See Fig a )

• Firmly screw the grinder ring onto the grinder head. (See Fig b )

SAUSAGE STUFFING DIRECTIONS

• Properly prepare casings as directed on the casing packaging. Place artificial or natural

• intestines onto the sausage funnel.

• Load the hopper with prepared meat and feed meat into the grinder head opening before

3.

4.

5.

6.

7.

8.

• to auger and/or motor can occur.

Plug in and turn the switch to the on position when ready to start.

• Begin to feed the sausage mixture into the hopper opening. (See Fig c )

• Hold the casing on the sausage tube in one hand and slowly let the meat output pull the casing

•

•

• from the tube. Fill casing as desired by holding casing back on tube.

Twist or tie the sausage into links as desired. Tie end of casing into a knot.

It is recommended that 2 people perform sausage stuffing.

Add small amounts of water to your ground meat when stuffing sausage to improve output of of meat through sausage stuffing tube.

Fig. A Fig. B Fig. C

AFTER USE

1.

Fig. b

Disassemble all parts and wash thoroughly in soapy water.

Fig. c

2.

3.

You must remove all foreign material from all appliance parts.

AFTER USE

4.

5.

• Disassemble all parts and wash thoroughly in soapy water.

• You must remove all foreign material from all appliance parts.

• Dry all surfaces.

• Do not use bleach or chlorine based chemicals to clean. Discoloration of plastic parts can occur.

6.

• Wipe down all non stainless steel parts with a food-safe grade spray. Alternatively, wipe down with a salad oil to keep from rusting.

• Do not immerse motor housing in water. Damage to motor can occur.

User Manual

User Manual

SAUSAGE STUFFING ASSEMBLY

• Be sure the grinder is unplugged.

• Attach grinder head to motor and install auger as previously described in General Assembly instructions.

• Slide the stuffing plate onto auger. The grinding blade is not used when stuffing.

• Slide one of the stuffing tubes through the funnel flange and place in the grinder ring cap

(stuffing tube faces out). The stuffing tube size used depends on the type of casing you have chosen to use.(See Fig a )

• Firmly screw the grinder ring onto the grinder head. (See Fig b )

SAUSAGE STUFFING DIRECTIONS

• Properly prepare casings as directed on the casing packaging. Place artificial or natural

• intestines onto the sausage funnel.

• Load the hopper with prepared meat and feed meat into the grinder head opening before operating unit. Reminder: Do not operate the grinder without meat in the grinder head. Damage to auger and/or motor can occur.

• Plug in and turn the switch to the on position when ready to start.

• Begin to feed the sausage mixture into the hopper opening. (See Fig c )

• Hold the casing on the sausage tube in one hand and slowly let the meat output pull the casing from the tube. Fill casing as desired by holding casing back on tube.

• Twist or tie the sausage into links as desired. Tie end of casing into a knot.

• It is recommended that 2 people perform sausage stuffing.

• Add small amounts of water to your ground meat when stuffing sausage to improve output of meat through sausage stuffing tube.

Fig. a Fig. b Fig. c

AFTER USE

• Disassemble all parts and wash thoroughly in soapy water.

• You must remove all foreign material from all appliance parts.

• Dry all surfaces.

• Do not use bleach or chlorine based chemicals to clean. Discoloration of plastic parts can occur.

• Wipe down all non stainless steel parts with a food-safe grade spray. Alternatively, wipe down with a salad oil to keep from rusting.

• Do not immerse motor housing in water. Damage to motor can occur.

4 www.AvantcoEquipment.com

www.AvantcoEquipment.com 5

User Manual

Parts Key

15

16

17

18

19

20

21

11

12

13

14

22

23

24

25

26

8

9

10

6

7

4

5

Parts Diagram # Part Name

1

2

3

Bronze Bushing

Grinder Housing

Nylon Washer

Back Pin

Auger

Auger Front Pin

Grinder Knife

Round Knife

Funnel

Retaining Ring

Oil Screw

Gear Box

Clamp Spring

Bearing

Bushing

Worm Wheel Gear

Bearing

Flat Key

Worm Shaft

Oil Seal

Adapter Sleeve

Socket Head Screw

Nut

Worm

Motor

Hex Wrench

Replacement Part #

177PMG123 (MG12),

177PMG223 (MG22)

177PMG125 (MG12),

177PMG225 (MG22)

177PMG126 (MG12),

177PMG226 (MG22)

177MG12KNIFE (MG12),

177MG22KNIFE (MG22)

177PMG1210 (MG12),

177PMG2210 (MG22)

177PMG16

177PMG1211

34

35

36

37

31

32

33

38

39

40

Parts Diagram # Part Name

27

28

Socket Head Screw

Handle

29

30

Seal Screw

Locking Thumbscrew

41

42

43

Not Shown

Not Shown

Not Shown

Replacement Part #

177PMG1230 (MG12),

177PMG2230 (MG22)

Enclosure

Power Cord Bushing

Power Cord

Relay

On / Off Switch

Bottom Plate

Rubber Foot

Sausage Stuffing Tubes

Sausage Stuffing Plate

177PSL40

177MGRFEET

M6 Screw

Hex Head Bolt

Stainless Steel Food Pan 177MG12PAN (MG12),

177MG22PAN (MG22)

Plastic Pusher 177MGSTOMP

Starting Capacitor

Running Capacitor

Grinder Plates 177MG1243 (MG12),

177MG1246 (MG12),

177MG1247 (MG12),

177MG2246 (MG22),

177MG2247 (MG22)

177MG12TUBE (MG12),

177MG12TUBE2 (MG12),

177MG12TUBE3 (MG12),

177MG22TUBE (MG22),

177MG22TUBE2 (MG22),

177MG22TUBE3 (MG22)

177MG12PSTUF (MG12)

177MG22PSTUF (MG22)

6 www.AvantcoEquipment.com

User Manual

Equipment Limited Warranty

Avantco warrants its equipment to be free from defects in material and workmanship for a period of 1 year. This is the sole and exclusive warranty made by Avantco covering your Avantco brand equipment. A claim under this warranty must be made within 1 year from the date of purchase of the equipment. Only the equipment’s original purchaser may make a claim under this warranty. Avantco reserves the right to approve or deny the repair or replacement of any part or repair request. The warranty is not transferable. Avantco Equipment installed in/on a food truck or trailer will be limited to a period of 30 days from the original date of purchase.

To Make a Warranty Claim:

For Warranty Inquiries contact the location where you purchased the product:

• WebstaurantStore.com: Contact [email protected]

. Please have your order number ready.

• The Restaurant Store: If you purchased this unit from your local store, please contact your store directly.

• TheRestaurantStore.com: Online purchases, call 717-392-7261. Please have your order number ready.

Failure to contact the designated location prior to obtaining equipment service may void your warranty.

Avantco makes no other warranties, express or implied, statutory or otherwise, and HEREBY DISCLAIMS ALL IMPLIED

WARRANTIES, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND OF FITNESS FOR A

PARTICULAR PURPOSE.

This Limited Warranty does not cover:

• Equipment sold or used outside the Continental United States

• Use of unfiltered water (if applicable)

• Avantco has the sole discretion on wearable parts not covered under warranty

• Equipment not purchased directly from an authorized dealer

• Equipment used for residential or other non-commercial purposes

• Equipment that has been altered, modified, or repaired by anyone other than an authorized service agency

• Equipment where the serial number plate has been removed or altered.

• Damage or failure due to improper installation, improper utility connection or supply, and issues resulting from improper ventilation or airflow.

• Defects and damage due to improper maintenance, wear and tear, misuse, abuse, vandalism, or Act of God.

Any action for breach of this warranty must be commenced within 1 year of the date on which the breach occurred.

No modification of this warranty, or waiver of its terms, shall be effective unless approved in a writing signed by the parties. The laws of the Commonwealth of Pennsylvania shall govern this warranty and the parties’ rights and duties under it. Avantco shall not under any circumstances be liable for incidental or consequential damages of any kind, including but not limited to loss of profits. www.AvantcoEquipment.com 7