REAR END STATION BRACKETS
ASSEMBLY
Kit Contents:
(2) Main Support Brackets
(2) Clamp Jaws
(4) 1/2"-13 x 3"
(Partial Threaded Bolts)
(2) 1/2"-13 x 4"
(Fully Threaded Bolts)
(8) Hex Nuts
(4) Washers
1.) Attach main support brackets to engine stand with (4) 3" bolts, washers and hex nuts
2.) Attach clamp jaws to main support brackets with (2) 4" bolts and hex nuts.
3.) Place rear end assembly onto station brackets, tighten clamp jaws to hold in place.
• Adjust engine stand to accept Rear End Station Brackets
• Adjust width to accommodate differential housing
• Use clamp jaw and hex nut to secure rear axle
Insert 4" fully threaded bolt and secure with hex nut.
Allstar Performance 8300 Lane Dr., Watervliet, MI 49098
Phone: (269) 463-8000 Fax: (800) 772-2618 www.allstarperformance.com
Form 1150 Page 1 of 1 Rev. 111815