SWC-363
denver.eu
06/22
Cet appareil et ses accessoires sont recyclables
OU
Getting Started
Caution: When the first time you use the fitness tracker, please make sure to fully charge it before using. Please read this user guide carefully before using the product.
It contains important information for your safety as well as use and maintenance advice. Keep this user guide for future reference.
Safety Precautions
The product contains electrical components that could cause injury if not handled properly.
·Do not open the enclosure or disassemble the product.
·Do not expose the product to extremely high or low
temperatures.
·Do not use the product in a sauna or steam room.
·Do not leave the product in direct sunlight for an
extended period of time.
·Do not dispose the product in a fire, the built-in battery
can explode.
·The product features a built-in battery, which is not user
replaceable.
·Do not check call notifications or other data on the
product's screen while driving or in other situations
where distractions could be hazardous.
·The distance travelled may be inaccurate. It is for
reference only and should not be used as any
navigational reference.
·The product should usually rest a finger's width below
the wrist bone, as you would normally wear a bracelet.
·This product has been classified as lP67 daily waterproof.
ENG-1
Caution: The device may cause skin irritation. Prolonged contact may contribute to skin irritation or allergies in some users. If you notice any signs of skin redness, swelling, itchiness or other skin irritation, please discontinue using the product. Continued use, even after symptoms subside, may result in renewed or increased irritation. If symptoms persist, consult your doctor. Do not open the enclosure or disassemble the product.
Blood Oxygen Notice
·WARNING! Only a medical practitioner is qualified to
interpret your blood oxygen measurements. The use of
this smart bracelet should not replace regular medical
examinations.
·Blood Oxygen can be subjected to wide fluctuations in
a short period of time. Its level depends on many factors.
·Different medicines, alcohol and smoking can exert a
large influence on the level of Blood Oxygen. Do not
smoke, drink caffeinated beverages or exercise within
the 30 minutes before measuring your blood oxygen.
Intended Use
This smart bracelet is intended for monitoring fitnessrelated metrics such as heart rate, blood pressure, distance walked or run, calorie consumption and quality of sleep. Data measured should not be used for any medical, ambulatory or dietary reference.
ENG-2
Product Overview
Charging contacts
Heart rate monitor
Power-on
Press and hold the side button for 3 seconds or plug in the magnetic charging cable to charge the smart watch.
ENG-3
Download and connect with smart watch App
1. Download and install App.
· Scan the QR code with your phone to download the
App.
· iOS system: search and download “Da Fit” from App
Store.
· Android system: search and download “Da Fit” from
Google Play.
Da Fit
Note: your mobile phone must support Android 5.1 or
IOS 8.0 or above, and Bluetooth 4.0 or above.
ENG-4
2. Connect smart watch with App.
1.Click "Add Device" to
find the smart watch.
2.Click on your device in
the device list scanned.
SWC-363
ENG-5
3. The iOS system will show a Bluetooth pairing request and you can click
"Pair" to confirm.
Android system connects with your watch directly.
4.Successfully bound.
SWC-363
SWC-363
Bluetooth Pairing Request
“SWC-363”would like to pair with
your iPhone.
ENG-6
Bluetooth call connection
Android phone:
1. After the App successfully connects to the watch's
Bluetooth, your phone will automatically pop up a
"pairing" request, click "Allow".
2. Some mobile phone models don’t need a pairing confirmation. After connecting the watch with App, the Bluetooth connection for call function is also established. Then you can answer and make calls on the watch. iOS phone: Go to Settings > Bluetooth, search for the device SWC-363 and pair with it. After the devices are connected successfully, you can make and answer calls from your watch.
Remove Bluetooth call connection
Android phone: The device can be disconnected from your mobile phone by simply clicking on “Remove device”.
iOS phone: Go to Settings > Bluetooth, select SWC-363, then click “Forget This Device”, your watch and mobile phone are now disconnected.
ENG-7
Smart watch functions
Swipe the touchscreen to switch the menu interface and access the various features of the watch. The interfaces are shown below:
ENG-8
Remove the device
For Android phones, the device can be disconnected from your mobile phone by simply clicking “Remove device”.
For iOS phones, after binding removal from the App, go to Settings > Bluetooth, then click “Forget This Device”.
SWC-363
1
ENG-9
2
SWC-363
SWC-363
3 4
ENG-10
Frequently Asked Questions (FAQs)
1. Why does the smart watch automatically disconnect Bluetooth when the Android phone’s screen is locked?
1 > Lock background App. When the Da Fit process is
cleared, the smart watch will be disconnected from
the mobile phone.
2 > Allow App self-startup.
3 > Allow unrestricted background operation. The
Android mobile phone intelligently restricts the
background operation of Apps by default. Users need
to manually allow the App to run in the background.
2. Why can’t the smart watch receive message push?
1 > Please confirm that you have turned on the switch for
message push in notification on mobile phone.
2 > Please confirm that messages can be displayed
normally in the mobile phone notification bar. The
message push on the smart watch is gone after you
read the message from the mobile phone notification
bar. The smart watch will not receive the message
push if there is no message in the mobile phone
notification bar. (You need to find notification settings
in the mobile phone settings, and turn on the
notification switch for WeChat, QQ, call, SMS and
others.
ENG-11
3 > Go to settings on your mobile phone. Write
“Notification use" in the search box, close settings
and re-open Da Fit.
3. Can I wear the smart watch in a bath, sauna or hot tub?
No. The bath water has a relatively high temperature and generates a lot of vapor which is in the gas state with small molecular radius and can easily infiltrate into the smart watch from the shell gap. When the temperature drops down, the vapor will condense into liquid droplets which can easily cause short circuit and thus damage the smart watch.
Warning:
Please consult your doctor before starting a new exercise program. The smart watch should not be used for any medical purpose though it may dynamically monitor the heart rate in real time.
ENG-12
Please notice - All products are subject to change without any notice. We take reservations for errors and omissions in the manual.
ALL RIGHTS RESERVED, COPYRIGHT DENVER A/S
denver.eu
Electric and electronic equipment and included batteries contains materials, components and substances that can be hazardous to your health and the environment, if the waste material (discarded electric and electronic equipment and batteries) is not handled correctly.
Electric and electronic equipment and batteries is marked with the crossed out trash can symbol, seen above. This symbol signifies that electric and electronic equipment and batteries should not be disposed of with other household waste, but should be disposed of separately.
As the end user it is important that you submit your used batteries to the appropriate and designated facility. In this manner you make sure that the batteries are recycled in accordance with legislature and will not harm the environment.
ENG-13
All cities have established collection points, where electric and electronic equipment and batteries can either be submitted free of charge at recycling stations and other collection sites, or be collected from the households.
Additional information is available at the technical department of your city.
Hereby, Denver A/S declares that the radio equipment type SWC-363 is in compliance with Directive 2014/53/
EU. The full text of the EU declaration of conformity is available at the following internet address: denver.eu and then click the search ICON on topline of website.
Write model number: SWC-363. Now enter product page, and RED directive is found under downloads/other downloads.
Operating Frequency Range:2402MHZ-2480MHZ
Max Output Power:4.2W
DENVER A/S
Omega 5A, Soeften
DK-8382 Hinnerup
Denmark www.facebook.com/denver.eu
ENG-14
Contact
Nordics
Headquarter
Denver A/S
Omega 5A, Soeften
DK-8382 Hinnerup
Denmark
Phone +45 86 22 51 00
(Push “2” for support)
E-Mail
For technical questions, please write to: [email protected]
For all other questions please write to: [email protected]
Germany
Denver Germany GmbH Service
Gutenbergstrasse 1
94036 Passau
Phone +49 851 379 369 40
E-Mail [email protected]
Fairfixx GmbH
Repair and service
Rudolf-Diesel-Str. 3 TOR 2
53859 Niederkassel
(for TV, E-Mobility/
Hoverboards/
Balanceboards, Smartphones
& Tablets)
Phone +49 851 379 369 69
E-Mail denver@fairfixx.de
Austria
Lurf Premium Service GmbH
Deutschstrasse 1
1230 Wien
Phone +43 1 904 3085
E-Mail [email protected]
Benelux/France
Denver BENELUX BV
Barwoutswaarder 13C+D
3449 HE Woerden
The Netherlands
Phone +31 348 420 029
E-Mail [email protected]
Spain
Denver SPAIN S.A.
C/ Moscú, 1 Pol.Ind.Mas de Tous
46185 La Pobla de Vallbona
Valencia (Spain)
Phone +34 960 046 883
E-Mail [email protected]
Portugal
Phone +35 1255 240 294
E-Mail denver.service@satfiel.com
If your country is not listed above, please write an email to [email protected]
Denver A/S
Omega 5A, Soeften
DK-8382 Hinnerup
Denmark denver.eu
