WINE COOLER

 URSIN
WINE COOLER
— = —
eo
|
ED-WC40B
Instruction Manual
Table of Contents
Parts and Features
Important Safety Instructions-
Installation Instructions
Before Using Your Wine Cooler --
Installation of Your Wine Cooler
Reversing the Door Swing of Your Wine Cooler
Operating Your Wine Cooler
How To Use The Thermostat -
Care and Maintenance
Change The Light Bulb
Cleaning Your Wine Cooler
Maintenance Your Wine Cooler -
Vacation Time
Moving Your Wine Cooler-
Troubleshooting
Technical Specifications --
PARTS AND FEATURES
REVERSIBLE DOOR
1. LAMP SWITCH
2. CABINET
3. LEVELLING LEG
4. WINE RACK
5. GLASS DOOR
6. SHELVES
7. INTERIOR LAMP
8. THERMOSTAT KNOB
Important Safety Instructions
* Read all instructions before using the appliance.
Before you throw away your old wine cooler:
take off the door, leave the shelves in place, so that children may not
easily climb inside.
* Never clean appliance parts with flammable fluids. The fumes can create
a fire hazard or explosion.
+ Do not store or use gasoline or any other flammable vapours and liquids
in the vicinity of this or any other appliance. The fumes can create a
fire or explosion.
* This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
« Children should be supervised to ensure that they do not play with the appliance.
INSTALLATION INSTRUCTIONS
Before Using Your Wine Cooler
« Remove the exterior and interior packing, including protective foam on
door panels.
* Check to be sure the following parts are included:
« shelves
« wine rack
« user manual
Before connecting the appliance to the power source, let it stand
upright for approximately 2 hours. This will reduce the possibility
of a malfunction in the cooling system from handling during
transportation.
+ Clean the interior surface with lukewarm water using a soft cloth.
Installation of Your Wine Cooler
e Place your appliance on a floor that is strong enough to support the
appliance when it is fully loaded. To level your appliance, adjust the
legs at the front of the appliance.
» Allow 5 inches of space between the back and sides of the appliance,
which allows the proper air circulation to cool the compressor.
Locate the appliance away from direct sunlight and sources of heat
(stove, heater, radiator, etc.). Direct sunlight may affect the acrylic
coating and heat sources may increase electrical consumption.
e Extreme cold ambient temperatures may also cause the appliance
not to perform properly.
e Avoid locating the appliance in moist areas. Too much moisture in
the air will cause frost to form quickly on the evaporator.
Plug the appliance into an exclusive properly installed-grounded wall
outlet. Do not under any circumstances cut or remove the third
(ground) prong from the power cord. Any questions concerning
power and or grounding should be directed toward a certified
electrician or an authorized products service center.
Warning: Improper use of the grounded plug can result in the risk of
electrical shock. If the power cord is damaged, have it replaced by an
authorized products service center.
Warning: Keep ventilation openings, in the appliance enclosure or in the
built-in structure, clear of obstruction.
Reversing the Door Swing of Your Wine Cooler
This wine cooler has the capability of either opening the door from the left
or right side. The unit is delivered to you with the door opening from the
left side. Should you desire to reverse the opening direction, please
follow these instructions.
NOTE:
Before Reversing the door ,the power must be shut off.
All parts removed must be saved to do the reinstallation of the door.
This wine cellar has been built with the door hinges on the right. If you wish
to change the opening direction, follow the instructions below:
1. Remove the upper hinge cover(6) first.
2. Remove the two screws (1) that hold the upper hinge (5) (right side) to the
frame. Take away the upper hinge (5).
3. Lift the door and place it on a padded surface to prevent scratching it.
4. Remove the two screws(8) that hold the lower hinge(2) and
remove the lower hinge(2).
. Remove the left front leg (4) and transfer it to the right side.
. Remove the hole cover plate(7) to the right side.
7. Before placing this lower hinge(2), remove the bolt-pin (9) and reverse
the direction of the lower hinge(2). Then install the lower hinge (2) onto
the left side of the lower frame with two screws (8).
8. Insert the bolt-pin(9) to the lower hinge (2).
9. Set the door to its place making sure the door is aligned withthe lower hinge(2).
10. While holding the door in the closed position secure the upper hinge (5) in the
top frame of left side with two screws (1). Please remember that do not tighten
the two screws(1) until the top of the door is levelled with the counter top.
11. Install the upper hinge cover(6) on the upper hinge.
К
ay QT
iF /
/ // /
of “a ©
FIGURE 1 FIGURE 2
Door opening from left side Door opening from right side
IMPORTANT SAFEGUARDS
Do not store food in the wine cooler, as the interior temperature may not get cool
enough to prevent spoilage. As a natural result of condensation, in summer
months or areas of high humidity, the glass door may built up moisture on
the outside. Just wipe it away.
WARNING: Do not use electrical appliances inside the food storage
compartments of the appliance, unless they are of the type
recommended by the manufacturer.
OPERATING YOUR WINE COOLER
It is recommended you install the wine cooler in a place where the ambient
temperature is between 22 -25 degree Celsius .If the ambient temperature
in above of below the recommended temperature ,conditions may cause
interior temperature to fluctuate.
If the interior light is left on, the temperature inside the wine cooler will be higher.
Recommended Temperatures for chilling Wine
Red wines: 15.5-18.5C
Dry/White Wines 10-15
Sparkling Wines 7.2-9.5°C
Rose Wines 9.5-10.5C
The above temperatures may fluctuate depending on whether or not the interior
bulb is on or off of whether the bottles are located on the lower/middle or lower
section.
HOW TO USE THE THERMOSTAT
Turn the thermostat knob, you can e NORMAL
adjust the temperature of the
compartment you desire. Turn it у
clockwise, the temperature of the
compartment will become cooler
and cooler. To store red wine you WARM “e
can adjust it anti-clockwise, to store OFF e” COLD
white wine you can adjust it clockwise.
Shelves
To accommodate different size bottles, the shelves
can be moved up or down by sliding them out the tracks first. Shelves are
designed to accommodate maximum amount of bottles.
Wine Rack
There is an additional wine rack at bottom section of the unit where you
can store up to wine bottles. This rack is removable for cleaning purpose.
There is a 4 to 6 C variance between the top and bottom shelves of the
wine chiller. Therefore, If you have set the wine chiller for red wine only
and you want to place a mix of white and red wines, you should place the
white wine bottles on the bottom shelves and the red wines on the top
shelves.
CARE AND MAINTENANCE
CHANGING THE LIGHT BULB
NOTE:
All parts removed must be saved during the replacement of the light bulb.
Before removing the light bulb, either unplug the refrigerator or disconnect
the electricity leading into the refrigerator at the main power supply. Failure
to do so could result in electrical shock or personal injury.
Light bulb should not exceed 5 watts.
Cleaning Your Wine Cooler
Unplug the wine cooler, and remove the bottles.
Wash the inside with a warm water and baking soda solution. The solution
should be about 2 tablespoons of baking soda to a liter of water.
Wash the shelves and trays with a mild detergent solution.
The outside of the wine cooler should be cleaned with mild detergent and
warm water.
It may also be necessary to periodically wipe the bottom part of the storage
area, as the wine cooler is designed to retain humidity, and condensation
may collect there.
Warning: Do not use mechanical devices or other means to accelerate the
defrosting process, other than those recommended by the
manufacturer.
Warning: Do not damage the refrigerant circuit.
Maintenance of Your Wine Cooler
Power Failure
Most power failures are corrected within a few hours and should not
affect the temperature of your wine cooler if you minimize the number
of times the door is opened. If the power is going to be off for a longer
period of time, you need to take the proper steps to protect your contents.
Vacation Time
During long absences, remove all the bottles; unplug your wine cooler, clean
your wine cooler, and leave the door open slightly to avoid possible formation
of condensation, mould, or odours.
Moving Your Wine Cooler
Remove all the bottles.
Securely tape down all loose items inside your wine cooler.
Turn the levelling screws up to the base to avoid damage.
Tape the doors shut.
Be sure the wine cooler stays in the upright position during transportation.
Troubleshooting
You can solve many common wine cooler problems easily, saving you the
cost of a possible service call. Try the suggestions below to see if you can
solve the problem before calling the servicer.
TROUBLESHOOTING GUIDE
PROBLEM | POSSIBLE CAUSE |
Wine cooler does| Not plugged In. |
| not operate. | The circuit breaker tripped or blown fuse.
Check to be sure the temperature control setting.
External environment may require a higher setting.
Wine cooler is |
The door is opened too often. |
|
not cold enough.
The door is not closed completely.
The door gasket does not seal properly.
The wine cooler does not have the correct clearances.
The room temperature is hotter than normal.
A large amount of contents has been added to the wine
cooler.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
The wine cooler does not have the correct clearances.
Compressor turns
on and off frequently.
The light does The home circuit breaker or fuse has tripped.
not work. The wine cooler is unplugged.
The bulb has burned out.
The switch is in the "OFF" position.
Vibrations. Ensure that the wine cooler is level.
The wine cooler The rattling noise may come from the flow of the
seems to make refrigerant, which is normal.
too much noise. As each cycle ends, you may hear gurgling sounds
caused by the flow of refrigerant in your wine cooler.
Contraction and expansion of the inside walls may
cause popping and crackling noises.
The wine cooler is not level.
The door will not The wine cooler is not level.
close properly. The doors were reversed and not properly installed.
The gasket is dirty.
The shelves are out of position.
*For the detailed technical specifications, please refer to the nameplate at
the back of the refrigerator.
*Specifications are subject to change without prior notice.
9