Backlighting
MENU
Press and hold x3
Race timer
Once the countdown timer reaches zero it will start counting up showing the elapsed time from zero. The timer will continue to count until it is stopped.
SET the value of the timer
MENU
Once SET is selected, use the directional keys to set the required time (whole minutes only).
START the timer
If a time value is preset, the timer will countdown. If the timer is on zero it will count up.
MENU
Synchronize the timer
Synchronizing the timer will cause the timer to reset to the nearest whole minute.
STOP the timer.
¼ Note: Press Enter again to restart the timer.
www.bandg.com
988-10636-001 - 1/5
Race Display
Quick Reference Guide
1
2
3
MENU
2
4
Keys
1
Page key: Exit from menu system and return to last active page.
Repeating presses: scroll through the 5 data pages in rotation. Press and hold: save the current page configuration.
2
Arrow keys: Switch between upper/lower half of the display when changing variables.
Scroll through options. Increase/decrease values.
3 Enter key: Enter the selected menu option. Confirm change/selection.
4
MENU / Lights key: Enter the menu system. Repeating presses: scroll through the menu options. Press and hold: enter the lights settings.
Display elements / symbols
1
2
5
2
4
1
No. Description
1 Data variable / menu name
2 Data value
3 Unit of measure
4 Bargraph data type
5 Bargraph data
6
The icon flashes when the Page key is held to store a page configuration
7 Alarm - Critical
3 6
7
8
9
11
10
12
13
3
No. Description
8 Alarm - Warning
9 Alarm - Info
10 Controlling remote (HV) display
11 Autopilot engaged
12 Active page number
13 B&G CPU on the network
EN
Page navigation
Menu system
MENU
Press the MENU key to access the menu options i.e. the first menu option is TIMER, then
REMOTE etc. - selecting the options clockwise as per the above illustration.
Press Page to exit from menu system and return to last active page.
Configuring a page
Save current page configuration: Press and hold till the update icon stops flashing
Configuring remote displays
MENU x2
Use the up/down and Enter keys to navigate to a variable and select the variable to display.
Exit with Page key.
Enabling alarm messages
MENU x8
Alarm notification - depth alarm example
When an alarm event is received the display will change to show the variable name that is alarming and the current value. An icon will be highlighted to indicate the severity of the alarm.
Acknowledging an alarm x2
This will remove the alarm notification
(text, light and sound) from all units on the network. A reminder will reappear at given intervals for as long as the alarm condition exists.
