CONKER ST8

Quick Start Guide

Powering on your phone:

To power on: Press and hold the power button for 3 seconds.

To power off: Press and hold the power button for 3 seconds, select ‘Power off’ in the menu.

17

20

21

1. Application button

2. Home button

3. Back button

4. Speaker (voice)

5. Proximity sensor

6. Front camera

7. Volume up

12.

13.

14.

15.

16.

17.

18.

Speaker

Speaker

Reset button

SIM card slot

Micro SD slot

Flash

Rear camera

8. Volume down

9. Power button

10. Headphones

11. Mini USB port

19. Micro USB port

(charging)

20. HDMI output

21. Microphone

Application button: View open applications.

Home button: Return to home screen.

Back button: Return to previous screen.

Reset Key: Immediately power off the phone.

Inserting the SIM Card and micro SD memory card:

Attention: Please power off the phone before changing the SIM cards.

1. Open the port cover at the top of the tablet.

2. Insert the SIM cards in the SIM holder:

Please take care to observer the correct orientation of the SIM card. With the tablet screen facing you orientate your SIM cards as per the picture to the right.

3. To remove the SIM card we recommend using a pair of tweezers. In some countries this tool will be provided in the product box.

Charging your tablet:

Your tablet should be charged via the Micro USB socket on the right edge of the device as pictured below

(labelled as part 19 in the diagram on the first page of this manual).

Please use a 5V / 2 Amp charger when possible. The battery in your tablet is a very high capacity and using a lower power output charger will result in very slow charging, e.g. charging from a computer may only offer

0.5 amps.

Connecting to a PC:

To connect your device to a PC please use the same

Micro USB port above that is used for charging.

Connecting headphones:

To access the headphone jack open the dust cover at the bottom of the tablet.

The headphone jack is on the left.

Please note: The Mini USB port on the right is currently unused. Please do not connect anything to the Mini USB port.

Using NFC

The NFC antenna position is marked in red below.

Notes:

Further Information:

For further information and support contact your reseller or visit www.conkertab.com

CONKER