2 Channel Wireless UHF Microphone System
With Individual Channel Level Control
AM-4114
User Manual
Specifications:
Frequency:
Transmission Range:
Microphone Power:
Pick up:
CH1: 525.1MHz
CH2: 645.9MHz
60m
2 x AA per Microphone
Dynamic
Dimensions:
Flyout:
1.
2.
3.
4.
5.
6.
7.
8.
Antenna
Mix Out
Power Input
Balance Output
Power Button
Volume Control
LED Indicators
Power Switch
Microphone: 240(L) x 50(Dia.) mm
Receiver: 210(L) x 140(D) x 42(H) mm
Installation and Operation (Receiver)
For best results, the receiver should be placed at least 1m off the ground, and should not be placed directly in front of the speaker system.
Connect the antenna, a balanced cable AF line (not supplied) to your speaker or amplifier system, and plug in the power adapter.
Adjust the antenna so that it is vertical.
Switch on the power, and while it is in stand-by, turn on the power of your speaker or amplifier system.
Ensure not to use two machines with the same frequency at the same place at the same time.
Installation and Operation (Transmitter)
Open up the battery compartment of the microphone, insert 2 x AA batteries and close the battery compartment.
Switch on the power and the power light will flash once.
The signal level on the receiver will light up to indicate that an effective signal is being received.
Adjust the channel volume and the volume on your speaker or amplifier system.
When the AF level lights up corresponding to the volume, the system is functioning normally.
Distributed by:
TechBrands by Electus Distribution Pty. Ltd.
320 Victoria Rd, Rydalmere
NSW 2116 Australia
Ph: 1300 738 555
Int’l: +61 2 8832 3200
Fax: 1300 738 500 www.techbrands.com
