Visit website for available languages of this document.
UNIVERSAL RAIN ACCESSORY
Bracket accessory for ULTIMO and IXIO sensors
sensor not included cover base
BEA, INC. INSTALLATION/SERVICE COMPLIANCE EXPECTATIONS
BEA, Inc., the sensor manufacturer, cannot be held responsible for incorrect installations or incorrect adjustments of the sensor/device; therefore, BEA, Inc. does not guarantee any use of the sensor/ device outside of its intended purpose.
BEA, Inc. strongly recommends that installation and service technicians be AAADM-certifi ed for pedestrian doors, IDA-certifi ed for doors/gates, and factory-trained for the type of door/gate system.
Installers and service personnel are responsible for executing a risk assessment following each installation/service performed, ensuring that the sensor/device system performance is compliant with local, national, and international regulations, codes, and standards.
Once installation or service work is complete, a safety inspection of the door/gate shall be performed per the door/gate manufacturer’s recommendations and/or per AAADM/ANSI/DASMA guidelines
(where applicable) for best industry practices. Safety inspections must be performed during each service call – examples of these safety inspections can be found on an AAADM safety information label
(e.g. ANSI/DASMA 102, ANSI/DASMA 107, UL294, UL325, and International Building Code).
Verify that all appropriate industry signage, warning labels, and placards are in place.
Tech Support & Customer Service: 1-800-523-2462 | General Tech Questions: [email protected] | Tech Docs: www.BEAsensors.com
©BEA | Original Instructions
75.0056.02 UNIVERSAL RAIN ACCESSORY 20221215 Page 1 of 2
MOUNTING & ASSEMBLY
1. Verify the existing mounting location orientation:
• ULTIMO: the bottom of the sensor is no more than 5” from the bottom of the door header
• IXIO: the bottom of the sensor is no more than 2” from the bottom of the door header
1
2. Place the Universal Rain Accessory (URA) base in the desired mounting location, and mark and drill pilot holes. Remove existing sensor if necessary.
2
3. Secure the URA base to the mounting location using the provided screws.
3
4. Secure the sensor to the URA base using the screws provided with the sensor.
4
5. Wire as instructed in the applicable sensor’s User’s Guide and secure the sensor cover.
5
6. Slightly pull the sides of the cover and insert the pin guides on the inside of the URA cover into the outside of the URA base.
©BEA | Original Instructions
75.0056.02 UNIVERSAL RAIN ACCESSORY 20221215
Visit website for available languages of this document.
75.0034.05 ULTIMO 20220708
ULTIMO
ACTIVATION AND SAFETY SENSOR FOR
AUTOMATIC, SLIDING DOORS
Software version 2.5 / Configuration version 7.0
(refer to Admin menu for product software vesion)
Page 1 of 20
6
Page 2 of 2
