LANCOM R&S®UF-300
Quick Reference Guide
4 a TP Ethernet interfaces eth0 - eth7
Connect the eth0 - eth7 TP Ethernet interfaces with the enclosed
Ethernet cable to your configuration PC or other networking components. Initial setup advice can be found in the supplied quick install guide.
b Configuration interface RJ45 (Console)
Maintenance interface for expert configuration c USB 2.0 interfaces
Interfaces for software re-installation eth0 | eth1 eth2 | eth3 a eth6 | eth7 b c
Console
Power
HDD
Reset d d Reset button (for powering on the device)
After having set the power switch on the device’s rear side to the “ I ” position, turn on the device by shortly pressing the button with a pointed device (e.g. a paper clip).
Pressing the button for 5 seconds shuts down the device.
e Power connector (rear side)
Connect the power cable to the device. After having supplied power the device can be switched on using the power switch.
f Power switch (rear side)
After having connected the power cable on the device’s rear side, set the power switch to the “ I ” position.
e f
Cloud-ready
4
Please observe the following when setting up the device
A The mains plug of the device must be freely accessible.
A Do not rest any objects on top of the device and do not stack multiple devices.
A Keep the device’s ventilation slots clear of obstruction.
Before initial startup, please make sure to take notice of the information regarding the intended use under www.lancom-systems.com/safety !
Operate the device only with a professionally installed power supply at a nearby power socket that is freely accessible at all times.
Reset eth0 | eth1 eth2 | eth3 a LEDs eth0 - eth7 - TP Ethernet
Both off
Left green flickering
Right orange, permanently
Left green, flickering
Right green, permanently
Left green, flickering
Right off
No networking device attached
Data transfer 1000 Mbps
Data transfer 100 Mbps
Data transfer 10 Mbps a eth6 | eth7
Console
Power
HDD
Reset b b LEDs Power / HDD / Reset
Power off
Power green
HDD off
HDD red flickering
Device switched off
Device operational no HDD read-/write access
HDD read-/write access
Hardware
Power supply Internal power supply unit (100–240 V, 50–60 Hz)
Power consumption Max. 150 W
Environment
Housing
Fans
Dimensions (mm)
Temperature range 0–40 °C; humidity 20–90 %; non-condensing
Robust metal housing, 1 HU with mounting brackets for 19“ installation, network connectors on the front
2
438 x 44 x 292 (W x H x D)
Interfaces
ETH
USB
Console
Package content
Documentation
Accessories
8x 10 / 100 / 1000 Mbps Gigabit Ethernet ports
2x USB 2.0 ports
RJ45 configuration interface
Declaration of conformity
Hereby, LANCOM Systems GmbH | Adenauerstrasse 20/B2 | D-52146 Wuerselen, declares that this device is in
compliance with Directives 2014/30/EU, 2014/35/EU, 2011/65/EU, and Regulation (EC) No. 1907/2006. The full text of the EU Declaration of Conformity is available at the following Internet address: www.lancom-systems.com/doc
Quick Reference Guide (DE, EN), Quick Install Guide (DE, EN), Service & Support Guide (DE, EN)
1 Ethernet cable; 1 IEC power cord; 1 serial configuration cable;
2 19” brackets for rack mounting
