CanDo 07-7067 Pneumatic Stool Manual
Add to My manuals1 Pages
Cando 07-7067 is a pneumatic stool with a backrest, designed to provide comfortable seating with adjustable height. It features a sturdy 5-point base with casters for easy mobility, and a pneumatic cylinder that allows for height adjustment from 17.91" to 23". The stool can support a maximum weight of 300 lbs and is easy to clean with soap and water or disinfectant wipes/spray.
advertisement
Button End
Pneumatic Stool With a Back
Assembly Instructions
Bottom End
REF
07-7067
LOT
Seat (1)
3”
(7.6 cm)
14” (35.6 cm)
Fig. 2
Pneumatic Cylinder (1) 5-Point Base (1) Caster Wheels (5) Back (1) Knob (1)
1. Remove protective cap from Pneumatic Cylinder. (Fig. 1) Place the seat upside down near the edge of a sturdy table. Put the button end of the pneumatic cylinder into the opening in the metal flange on the bottom of the seat. (Fig. 2) Use minimal force to press the cylinder into the opening.
2. Point the back rest towards the floor and slide the end of the L-Shaped shaft into the flange on the bottom of the seat. (Fig. 3)
Once the two (2) holes are lined up, insert the knob and twist it until it is tight.
2. Turn the 5-point base upside down. Press one (1) caster into each of the ends of the 5-point base. (Fig. 4)
3. Turn the 5-point base over and place it on level ground so it is resting on all
5 casters. Place the bottom end of the pneumatic cylinder into the center opening in the 5-point base. (Fig. 5)
Use minimal force to press the cylinder into the opening.
4. Carefully sit down on the seat* until the cylinder locks into place.
5. Using the lever under the seat, you can adjust its height as needed.
Height adjusts from 17.91” (45.5 cm) to 23” (58.5 cm). 5.25” (13.3 cm) total adjustability.
Cleaning Instructions
This item can be cleaned/sanitized using soap and water or a disinfectant, wipes/spray.
Cleaner/sanitizer should be applied after every use. Bleach and any other commercial disinfectants, such as Oxivir, is not permitted.
Fig. 1
CAUTION:
• Maximum Weight Rating – 300 lb (136 kg)
• If components are damaged or missing, contact your dealer immediately.
DO NOT use substitute parts.
* You need to weigh at lease 90 lb (41 kg) to adjust the height of the seat.
Fig. 3 Fig. 4 Fig. 5
Flange
Manufactured for:
Fabrication Enterprises Inc.
250 Clearbrook Rd, Suite 240
Elmsford, NY 10523 (USA) tel: +1-914-345-9300 • 800-431-2830 fax: +1-914-345-9800 • 800-634-5370
FabEnt.com
EC REP
Authorized CE representative:
AJW Technology Consulting GmbH
Breite Strasse 3
40213 Düsseldorf (Germany)
© 2022 FEI, all rights reserved.
CanDo and are trademarks of Goldberg.
Made in China
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
v0422
advertisement
Related manuals
advertisement