Aspects RFKIT22 22-Watt Equivalent T9 LED Dimmable Retrofit Kit Warm White Light Bulb Installation Guide
Add to My manuals1 Pages
advertisement
◉
Touch to zoom
Flushmount Fluorescent Replacement Safety Precautions Read all salety precautions and installation instructions carefitlfy Make sure {hal the power source conforms to the requirements of the before installing or servicing this fixture. Failure to comply with fixture. (See labels on fixture housing). these instructions could result in potentially fatal electric shock and/or property damage. To reduce the risk of electrical shock, and to assure proper operation, this fixture must be adequately grounded. To accomplish proper Н is recommended that all wiring be performed by a qualified erounding, there must be a separate ground wire (green) or bare metal electrician, This fixture must be wired in accordance with all national contact (metal conduit} between this fixture and the ground and local electrical codes. connection of your main power supply panel. The green ground screw location is clearly marked on the fixture housing. Do not handle any energized fixture or attempt to energize any lixture with wet hands or while standing on a wel or damp surface or This fixture is intended 10 be used for general indoor lighting in dry in water. or damp locations only. Circline model Assembly Instructions 1. Preparing for installation A. Disconnect electrical power before installing or servicing any part of this fixture. B. Remove diffuser. С. Remove circline lamp from fixture. 2. Wiring. Caution: Make sure power is off at fuse or circuit breaker box. Check power wires for damage or scrapes. If power supply wires are within three inches of ballast use wire suitable for at least 90°C (94°F), Note: Most dwellings built = + before 1985 have supply wire rated to 60°C, Consult a qualified electrician a N before installing. A. Cut black and white supply wires and strip Y” off ends. 3. Connect quick connectors (provided). to one end of white supply wire to and one to black hot supply wire. 3. Mounting. A. Attach LED Driver with magnets (provided) and place anywhere there is room on the metal pan. B. Attach LED module with magnets (provided) to center of metal pan. 4, Re-wiring A. Connect black wire from the input side of the LED driver into the quick connector that has the supply black wire. B. Connect white wire from the input side of the LED driver into the quick connector that has the supply white wire. Do not mix wires. Pull on each wire lead to make sure Retrofit Kit connections are secure. Make certain no bare wires are exposed outside of wire connectors. 5. Diffuser re-install. A. Re-install diffuser. 6. Power to the fixture can now be restored. Limited Factory Warranty AËX Ine. hereby warranty that this fixture is free from defects in materials and workmanship when installed and used under normal operating conditions for a period of 5 years [rom date of purchase. This warranty cavers all component parts and extends only to replacement of delective fixture or components; it does not cover failure due to improper installation, misuse, mishandling or damage incurred in transit. Page | of 1 3060398 rev.0 2345 М. Ernie Krueger Circle Waukegan, il. 60087
advertisement