SUNRICHER SR-SB9001K5-DIM RF+Bluetooth US Size Single Color Remote Controller Instructions

RF+Bluetooth US Size Single Color Remote Controller

09.SB901K5M.04754

Important: Read All Instructions Prior to Installation

Function introduction

Press and hold down to increase light intensity

Product Data

Output RF+Bluetooth

Operation Frequency

Relative humidity

Dimensions

2.4GHz

Power Supply

Operating temperature

3V(1xCR2032 battery)

0-40°C

8% to 80%

66x32.5x8.9mm

magnet

Press and hold down to save color, click to recall the saved

Press and hold down to decrease light intensity

Click to turn on the light

Click to turn off the light

• RF+Bluetooth Single color wall mounted remote control

• Enables to control 1 zone of receivers

• Easy & quick pairing to the RF+Bluetooth receivers by simply pushing the buttons

• Mesh network for further control distance, receivers can transmit signal to each other

• Each remote can control numerous receivers

• Each receiver can be paired to max. 8 remote controls

• The controlled receiver status can be quickly synchronized to the smart APP

• Transmission range between every two neighbor devices up to 30m

• Bluetooth low power consumption technology, long battery life

Safety & Warnings

• This device contains a button lithium battery that shall be stored and disposed properly.

• DO NOT expose the device to moisture.

Bracket Front side

Pair with RF+Bluetooth receiver

Step 1: Do wiring the RF+Bluetooth receiver according to wiring diagram(please refer to the instruction of RF+Bluetooth receiver that you would like to pair with.

Prog.

RF+Bluetooth LED Receiver

Step 2: Click the “ Prog. Key ” or “ Reset ” button on RF+Bluetooth receiver to set it into pairing status

Step 3: Click any button of the remote(e.g. button ), LED lights connected with the receiver flicker once means the receiver is paired to the remote successfully.

Note: one receiver can be paired with max 8 remote controls.

Note:Before the first use, please remove the protective film on the battery.

Back side

Installation

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

IC STATEMENT

This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:

(1) This device may not cause interference; and

(2) This device must accept any interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :

(1) l'appareil ne doit pas produire de brouillage, et

(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.