AUDEARA A02 Wireless Headset TV Bundle Installation Guide

A - 0 2

T V B U N D L E G U I D E

1.

TV

TRANSMITTER

OVERVIEW

Button A

Multifunction Button

Button B

Analog

Audio

Input

USB

Power

Digital Optical

Input

Audio

Input

Switch

Digital Optical

Output

2.

POWER THE

TV TRANSMITTER

The TV Transmitter is powered by a USB-C cable.

Connect the USB-C end (smaller tip) into the back of the transmitter.

Connect the USB-A end (bigger tip) into your TV

OR a USB wall charger.

TV

USB POWER

OR

USB Wall

Charger

(not included)

Now, you should see the transmitter welcome screen. If you don’t see this screen, ensure your TV or wall charger is powered on.

3.

CONNECT THE

TV AUDIO

The Transmitter can be connected to the TV three ways.

We recommend using OPTION A for the best experience.

OPTION A - TVs WITH DIGITAL AUDIO OUTPUT

TV

DIGITAL

OPTICAL AUDIO

Plug the

DIGITAL OPTICAL

cable into the TV

Transmitter

DIGITAL OPTICAL

INPUT

Slide the Audio Input

Switch to DIGITAL

Plug the other end into the

OPTICAL OUTPUT of your TV

OPTION B - TVs WITH 3.5mm HEADPHONE AUDIO OUTPUT

TV

ANALOG AUDIO

Plug the

ANALOG AUDIO cable into the

TV Transmitter

ANALOG AUDIO

INPUT

Slide the Audio Input

Switch to ANALOG

Plug the other end into the

TV HEADPHONE

AUDIO OUTPUT

OPTION C - TVs WITH RCA AUDIO OUTPUT (RED/WHITE PORTS)

TV

L R

ANALOG AUDIO

AV ADAPTER

Plug the

ANALOG AUDIO cable into the

TV Transmitter

ANALOG AUDIO

INPUT

Slide the Audio Input

Switch to ANALOG

Join the

AV ADAPTER and plug into the

TV RCA

AUDIO OUTPUT

4.

DISPLAY AND

STATUS

Connection

Status

Audio Input Selection Audio Codec

AUDEARA

Headphone A

Headphone B

A Paired and connected

Paired and disconnected

5.

IN THE BOX

TV Transmitter

USB

Power Cable

Digital Optical

Audio Cable

Analog

Audio Cable

AV Adapter Accessory Bag

6.

PRODUCT

SUPPORT

Visit our website or call our friendly support team for more information.

www.audeara.com/support

+61 1300 251 539

FCC AND IC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference,

2. This device must accept any interference received, including interference that may cause undesired operation.

CAN ICES-3(B)/NMB-3(B)

FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help

FCC CAUTION

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

ROHS COMPLIANCE

This product is in compliance with the European Union’s Restriction of Use of Hazardous Substances in

Electrical and Electronic Equipment (RoHS) Directive 2011/65/EU.

IC COMPLIANCE STATEMENT

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic

Development Canada’s licence-exempt RSS(s).

Operation is subject to the following two conditions:

1. This device may not cause interference.

2. This device must accept any interference, including interference that may cause undesired operation of the device.

CAN ICES-3(B)/NMB-3(B)

IC DECLARATION DE CONFORMITÉ

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:

1. L’ appareil ne doit pas produire de brouillage.

2. L’ appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’ en compromettre le fonctionnement.

CAN ICES-3(B)/NMB-3(B)

WEE NOTICE

This symbol on the product indicates that the product must not be disposed of with normal household waste. Instead, it is your responsibility to dispose of your waste equipment by arranging to return it to a designated collection point for the recycling of waste electrical and electronic equipment.

By separating and recycling your waste equipment at the time of disposal you will help to conserve natural resources and ensure that the equipment is recycled in a manner that protects human health and the environment.

Audeara offers our customers the opportunity to return products at the end of their functional lives to Audeara for recycling, qualifying products are marked with the WEEE symbol shown above. Delivery cost of any authorised product returned to Audeara will be at the expense of the sender.