Earbuds A2 TWS Wireless Earbuds User Manual

A2 wireless earbuds

First link: Press and hold the touch button for

3-4 seconds to turn on the earbuds At this time, the two earphones will flash red and blue. When one of the lights goes out, the earbuds will enter the pairing state. Click "A2" on the phone to link successfully.

Power on: long press for 3-4 seconds

Power off: long press for 5 seconds

Headphone reset: long press for 10 seconds to reset and restart the headphone (to prevent the headset from crashing)

Charging: Charging box and earphones, the red light is on

Fully charged: Charging box and earphones, the red light is off

Socket type：TYPE-C

1.Play/pause music: touch L/R on either side

2.Left ear: double-click the previous song / triple-click to reduce the volume

3.Right ear: double-click the next song / triple-click to increase the volume

4.

. Start SIEI: four click the L/R on either side

5.Answer the call: touch any side

6.Reject call: touch either side for two seconds

A2

1hours

8-10hours

Charge times : 4 times

15m

If your cellphone can't find'A2',please double check that your cellphone

Bluetooth is at visible mode.The earphone will automatically pair after initial repairing,but if no use for a long time ,it must be paired again.

FCC Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement.

The device can be used in portable exposure condition without restriction.