Sound Town PAC80-2 Public Address Amplifier User Manual

“<j SOUND TOWN
PAC80-2
PUBLIC ADDRESS AMPLIFIER WITH BLUETOOTH
“y SOUND TOWN
Sound Town Inc.
USER MANUAL
Los Angeles, California, USA
www.soundtown.com
© 2021 SOUNDTOWN // Features and specifications are subject to change and or improvement without notice.
IMPORTANT SAFETY INSTRUCTIONS
NOOR ON >
16.
17.
Read all safety and operating instructions before using this product.
All safety and operating instructions should be kept for future reference.
Read and understand all warnings listed on the operating instructions.
Follow all operating instructions to operate this product.
This product should not be used near water, ¡.e. Bathtub, sink, swimming pool, web basement etc.
Only use dry cloth to clean this product.
Do not block any ventilation openings, it should not be placed flat against a wall or placed in a built-in
enclosure that will impede the flow of cooling air.
Do not install this product near any heat sources, such as, radiators, heat registers, stove or other apparatus
(including heat producing amplifiers) that produce heat.
Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades
with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The side
blade or the third prong are provided for your safety if the provided plug does not fit into your outlet, consult
an electrician for replacement of the obsolete outlet.
. Protect the power cord being walked on or pinched particularly at Plugs, convenience receptacles and the
point where they exit from the apparatus. Do not break the ground pin of the power supply cord.
. Only use attachments specified by the manufacturer.
. Use only the cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus.
When a cart is used use caution when moving cart/apparatus combination to avoid injury from tip-over.
. Unplug this apparatus during lightning storms or when unused for long periods of time.
. Care should be taken so that objects do not fall and liquids are not spilled into the unit through the ventilation
ports or any other openings.
. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged
in any way; such as, power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into
the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally or has been
dropped.
WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.
When the MAINS plug, or an appliance coupler is used as the disconnect device, the disconnect device should
remain readily operable.
. Protective Ground Terminal: The apparatus shall be connected to an AC main socket with a protective earth
ground connection.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE CHASSIS. NO USER-SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
AVIS: RISQUE DE СНОС ELECTRIQUE-NE PAS OUVRIR.
FEATURES
@ 2 MIC and 2 LINE inputs
e 1 LINE output
e BLUETOOTH, USB, FM input with LED display
e Treble / Bass control & effect
e Over current, short circuit protection
e 70V / 100V outputs
e Low impedance 4-16 ohm outputs
e 2 zone outputs (70V) with individual volume control
e 1 PAC amplifier
e 1 Power cable
e 1 Remote control
e 1 User Manual
e 1 Warranty Card
IN THE PACKAGE
(EN
FRONT PANEL
uch
© © M OO 0 то
6OW 70V / 100V
la, SOUND TOWN PAC 80-2 COMMERCIAL 2-
ZONE AMPLIFIER
DS m
TREBLE VOLUME ZONE 1 ZONE 2
EOS || | |
оо 00000 ® DOVER
. POWER INDICATOR: The LED illuminates when the amplifier is turned on.
. MIC SOCKET: 2 x 1/4" jack are provided for microphone inputs.
. MIC LEVEL CONTROL: 1 rotated knobs to adjust the level of 2 microphone inputs signal.
. ECHO: To adjust the volume of echo effect.
. BASS: To increase or decrease the low frequency of the input signal.
. TREBLE: To increase or decrease the high frequency of the input signal.
. VOLUME: To adjust the overall volume.
. 2 ZONE VOLUME: Individual volume control for 2 zone, each knobs adjustable in 5 steps.
. PREV: Short press to jump to previous song; press and hold to enter rewinding state.
. PLAY/PAUSE.
. NEXT: Short press to jump to next song; press and hold to enterforwarding state.
. MODE: Press to switch the signal source from BLUETOOTH/USB/FM/LINE.
- IR: Infrared sensor for remote control.
. LED DISPLAY
. USB input socket.
. POWER SWITCH: To turn on/off the amplifier.
REAR PANEL
2 e
17.
18.
19.
20.
21.
22.
23.
24.
25.
25.
(D (9 9 @
£, SOUND TOWN
ZONE1 COM ZONE2 FM
FUSE
3A/250V
e o
70V SPEAKER ZONE OUTPUT AC INPUT
115V/60HZ
LINE1 LINE2
à
LINE, LINE2, INPUT: 2 x RCA conneciors are provided for 2 line level signal inputs.
LINE OUT: One RCA connector is provided for signal output (mixed output).
COM OUTPUT SOCKET: This is the common post, for whichever 70V/100V/4-160hm
connection, need to connect the negative ends to the 'COM' post.
LOW IMPEDANCE OUTPUT BINDING POST: For a 4-16 ohm low impedance speaker,
connect the positive ends to the '4-16 ohm' red post and the negative ends to the 'COM' post.
70V OUTPUT BINDING POST: To provide 70V voltage output, for your speaker with 70V
transformer, connect the positive ends to the "70V' red post and the negative ends to the 'COM'
post.
100V OUTPUT BINDING POST: To provide 100V voltage output, for your speaker with 100V
transformer, connect the positive ends to the '100V' red post and the negative ends to the 'COM'
post.
2 ZONE OUTPUT BINDING POST: To provide 70V voltage output dividing into 2 different zone.
Connect the positive ends to 'Z1' or 'Z2' post and connect all negative ends to the 'COM' post.
FM: To connect a extension antenna cable to the post for better FM signal receiving when needed.
FUSE HOLDER: 3A/250V fuse inside.
AC INPUT: This receptacle is for connecting the included IEC power cable. It is important to
supply the proper AC line voltage to the unit. Do not connect to intermittent or faulty power.
SPECIFICATIONS
MODEL PAC80-2
OUTPUT POWER 60W RMS
OUTPUT TYPE 70V/100V/4-160
MIC INPUT 3mV, 6000
LINE INPUT 200mV, 10kQ
FREQ. RANGE 40Hz~20kHz
DISTORTION 0.5% (1kHz)
S/N AUX 88 dB
RATIO MIC 116 dB
VOLTAGE AC115V/60Hz
DIMENSION 12.6" x 10.2" x 2.6"
PACKING SIZE 14.4" x 11.8" x 4.7"
N.W. 7.4 Lbs
G.W. 8.1 Lbs
How can we help you?
CONTACT OUR US-BASED SUPPORT TEAM
Simple or complex, your questions are important to us. For service, support
or more information, please contact the Sound Town support team:
Email: support @ soundtown.com