Skan
Design by Lievore, Altherr, Molina
ASSEMBLY INSTRUCTIONS
SUPPLIED MATERIAL
1.
0250
1 un.
1 Lamp structure
TECHNICAL SPECIFICATIONS
ESPECIFICACIONES TÉCNICAS
TECHNISCHE DATEN
Caution
Before assembling and installing this product, carefully read the following:
-If the steel cable or the power cord of this lamp is damaged, it must be replaced only by the manufacturer or their technical service or by a person capacitated to this effect
to avoid any risk.
-This lamp is for indoor use only, excluding bathrooms or any type of humid surface.
-We recommend reading the manual before installaing the lamp. Keep this instructions for future reference.
ASSEMBLY INSTRUCTIONS
1. The head of the Light can turn as shown by the
arrows.
2. The light is switched on and off by means of an
optical sensor mounted in the top of the head, by
giving it a quick tap. See detail 1a.
The brightness of the light is set by keeping the
optical sensor covered until the desired brightness
is achieved. See detail 1b.
Increase the brightness of the light (MAX.) by
keeping the sensor covered.
If it is pressed again the light is dimmed (MIN.).
For the sensor to work properly it should be kept
clean.
1
2
1a)
Maintenance
-Use a slightly-wet cotton cloth for cleaning.
-In case of malfunction or damage, please contact the retailer who sold the lamp.
1b)
">
