TRACEABLE 5667 4 Channel Timer User Guide

4-Channel Timer Quick-Start

Guide

WARRANTY, SERVICE, OR RECALIBRATION

Traceable ® Products are ISO 9001:2018 Quality-

Certi ied by DNV and ISO/IEC 17025:2017 accredited as a Calibration Laboratory by A2LA.

Item No. 56000-16

Model No. 5667

©2022 1065T9_M_92-5667-00 Rev. 0 09022022

1.888.610.7664

10

15

20

25

30 www.calcert.com

[email protected]

SETTING A TIMER STARTING A TIMER

1. Press CH/CLOCK button until the desired channel is solid (not flashing) on the screen.

2. Use the H/M/S buttons to configure timer.

Note: To clear and start over, press

CLEAR button.

• When starting/stopping an individual timer, navigate to that timing channel using the CH/

CLOCK button and then press START/STOP

ALL.

• To start/stop all timers, press the START/STOP

ALL button from the clock screen.

• Timers which are counting down will lash quickly.

• Timers which are counting up will lash slowly.

• Timers which have expired will lash rapidly.

1.888.610.7664

10

15

20

25

30 www.calcert.com

[email protected]

Traceable® 4-Channel Timer INITIAL SETUP



Remove battery cover and insert batteries

Battery

Start/Stop All button

Channel/Clock

Clear timer setting button

Seconds button

Minutes button Hours button



Replace battery cover



Press CH/CLOCK button until clock appears on top row of display.

1.888.610.7664

10

15

20

25

30 www.calcert.com

[email protected]

Hold CH/CLOCK until there is an audible beep and the time flashes



To adjust 12/24 hour clock, press and hold START/

STOP ALL button.



Use H/M/S buttons to adjust the time



Pressing Seconds button will round to the nearest minute.



Press the CH/CLOCK button to exit setup.

1.888.610.7664

10

15

20

25

30 www.calcert.com

[email protected]