4-Channel Timer Quick-Start
Guide
WARRANTY, SERVICE, OR RECALIBRATION
Traceable ® Products are ISO 9001:2018 Quality-
Certi ied by DNV and ISO/IEC 17025:2017 accredited as a Calibration Laboratory by A2LA.
Item No. 56000-16
Model No. 5667
©2022 1065T9_M_92-5667-00 Rev. 0 09022022
1.888.610.7664
10
15
20
25
30 www.calcert.com
[email protected]
SETTING A TIMER STARTING A TIMER
1. Press CH/CLOCK button until the desired channel is solid (not flashing) on the screen.
2. Use the H/M/S buttons to configure timer.
Note: To clear and start over, press
CLEAR button.
• When starting/stopping an individual timer, navigate to that timing channel using the CH/
CLOCK button and then press START/STOP
ALL.
• To start/stop all timers, press the START/STOP
ALL button from the clock screen.
• Timers which are counting down will lash quickly.
• Timers which are counting up will lash slowly.
• Timers which have expired will lash rapidly.
1.888.610.7664
10
15
20
25
30 www.calcert.com
[email protected]
Traceable® 4-Channel Timer INITIAL SETUP
Remove battery cover and insert batteries
Battery
Start/Stop All button
Channel/Clock
Clear timer setting button
Seconds button
Minutes button Hours button
Replace battery cover
Press CH/CLOCK button until clock appears on top row of display.
1.888.610.7664
10
15
20
25
30 www.calcert.com
[email protected]
Hold CH/CLOCK until there is an audible beep and the time flashes
To adjust 12/24 hour clock, press and hold START/
STOP ALL button.
Use H/M/S buttons to adjust the time
Pressing Seconds button will round to the nearest minute.
Press the CH/CLOCK button to exit setup.
1.888.610.7664
10
15
20
25
30 www.calcert.com
[email protected]
