Unbranded 8239205076 Replacement Ceiling Fan Blade for 52 in. Windward IV Oil Rubbed Bronze Fan Installation Guide

Assembly - Hanging the Fan (continued)

9

Mounting the fan

10

Close-to-Ceiling mounting

WARNING: When using the standard ball/downrod mounting, the tab in the ring at the bottom of the mounting bracket must rest in the groove of the hanger ball. Failure to properly seat the tab in the groove could cause damage to the wiring.

WARNING: The locking slots of the celling canopy are provided only as an aid to mounting. Do not leave the fan assembly unattended until all four canopy screws are engaged and firmly tightened.

□

Align the locking slots of the ceiling canopy (C) with the two screws (JJ) in the mounting bracket (A). Push up to engage the slots and turn clockwise to lock in place.

□

Firmly tighten the two mounting screws (JJ).

□ Install the two mounting screws (II) (saved from Assembly

Step 1 “Prepairing for mounting”) into the holes in the canopy (C) and tighten firmly.

□

Install the decorative canopy ring (FF) by aligning the ring’s slots with the screws in the canopy (C). Rotate the ring clockwise to lock in place.

A

II JJ

□

Carefully unhook the fan from the mounting bracket (A) and align the locking slots of the ceiling canopy (C) with the two screws in the mounting bracket (A). Push up to engage the slots and turn clockwise to lock the canopy (C) in place. Immediately tighten the two mounting screws (JJ) firmly.

□ Install the remaining two mounting screws (II) into the holes in the canopy (C) and tighten firmly.

□

Install the decorative canopy ring (FF) by aligning the ring’s slots with the screws in the canopy (C). Rotate the ring clockwise to lock it in place.

A

II JJ

FF

C

FF

C

E

E

Attaching the fan blades

□ Attach a blade (H) to the fan motor housing (E) by first inserting the blade (H) into the slot in the side of the fan motor housing (E).

□

Insert a screw (AA) into the bracket. Repeat for the two remaining screws.

□

Tighten each screw (AA) securely.

□

Repeat these steps for the remaining blades (H).

E

H

AA

12