AKG D12 VR Reference large-diaphragm dynamic microphone Data Sheet
Add to My manuals2 Pages
AKG D12 VR is a large-diaphragm cardioid dynamic microphone designed for capturing the low frequencies of kick drums and bass instruments. Its thin diaphragm enhances bass response, while the active filter circuitry, powered by 48V phantom power, provides three distinct sound shapes. The D12 VR also features a passive mode for use without phantom power and a zero latency calculator to align the microphone's signal with other tracks in a recording.
advertisement
![AKG D12 VR Reference large-diaphragm dynamic microphone Data Sheet | Manualzz AKG D12 VR Reference large-diaphragm dynamic microphone Data Sheet | Manualzz](http://s1.manualzz.com/store/data/007100622_1-0602d14bc550f6a01bd19c275a9e83f5-360x466.png)
D
REFERENCE KICKDRUM and
BASS MICROPHONE
KICK THE HAMMER
The D12 VR is a large-diaphragm cardioid enhance the low frequency performance.
Without phantom power, the microphone delivers the pure character of the sound source. This setting is perfect for loud wind instruments and also for vocal transformer from the 1970´s and a patented discrete circuitry. switch on the microphone body. In this mode the output level is also reduced by 10 dB automati
Active filter operation:
The implementation of an active electronic filter in a dynamic microphone is an AKG
“Phantom Power” must be supplied from the connected mixing desk in order to power the active filter circuitry.
The operating principle of the active filters is based on analogue circuitry combined
Frequency processing is performed in the filter circuit and then transformer. Impedance differences between the micr a perfect sound regardless of the connected device.
The resulting sound is especially impressive at high signal levels at which the transformer signal.
HIGHLIGHTS
» Patented analogue
» Cardioid polar pattern
» Dynamic passive mode
» Ultra thin diaphragm
» Optimized bass chamber
» 3 active sound shapes s/P48 power
» Zero latency calculator
» Original C414 transformer www.akg.com
D12 VR Technical Specifications
•
Transducer Principle: dynamic pressure gradient transducer
•
Polar Pattern: cardioid
•
Frequency Range: 17-17.000 Hz (± 2 dB)
•
Sensitivity at 1000 Hz passiv
•
Electrical Impedance at 1000 Hz: <200 ohms
•
Recommended Load Impedance: >1000 ohms
•
Maximum SPL for 0.5% THD: 164dB SPL
•
Climatic Conditions: temperature range: relative humidity at +20°C: 90%
•
Connector Type: three-pin male standard XLR
•
Connector Wiring: pin 1: ground, pin 2: AF (in phase), pin 3: AF (out phase)
•
Housing Material: metal
•
Grill Material: springsteel wire mesh
•
Finish: front grille glossy galvanized nickel matte, rear grille matte black paint
•
Dimensions: H 125mm , W 101mm , D 66mm
•
Weight: 500g
Included accessories:
Item Number:
AKG Acoustics GmbH Lemböckgas
AKG Acoustics, U.S. 8400 Balboa Boulevard, Northridge, CA 91329, U.S.A.
© 2012 HARMAN International Industries, Incorporated. All rights reserved. AKG is a trademark of AKG Acoustics GmbH, registered in the United States and/or other countries.
Features, specifications and appearance are subject to change without notice.
www.akg.com
advertisement
Related manuals
advertisement