advertisement
MAINTENANCE
1.
Turn off the power switch in the rear of the unit.
2.
Unplug the unit and let it cool completely.
3.
To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth.
CAUTION: DO NOT let liquid enter the heater.
4.
DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This may cause damage or deterioration to the surface of the heater.
5.
DO NOT immerse the heater in water.
6.
Wait until the unit is completely dry before use.
7.
Air filter needs cleaning after used 3 months of use. Please take off the filter with the 2 steps in the drawing below. Flush and clean the filter with water then dry it out and reassemble.
The unit 2) Remove Air filter
1) Remove bracket screws (2X)
8. If you do not use the heater for a long time, please take out the remote batteries (to prevent corrosion) as shown below. Store the remote in a safe place.
PUSH lid Battery
STORAGE
Store the heater in a cool, dry location when not in use. To prevent dust and dirt build-up, use the original packaging to repack the unit.
BASIC TROUBLESHOOTING
If the heater will not operate, please check the following before seeking repair advice:
1.
Check if the power cord is plugged into an electrical outlet, if not, plug in.
2.
Check if electricity to the main power switch (in the back) is working.
3.
Check to see if the battery on the remote is placed correctly, undamaged.
NOTE: For the heater to function properly, the desired temperature on the heater must be set a few degrees higher than the temperature in the room. If the seems to not be heating, increase the desired temperature on the heater to engage the heat elements.
2
advertisement