ABIT KV7 Socket 462 motherboard User's Manual

Below you will find brief information for motherboard KV7 Socket 462. This motherboard supports AMD Socket A processors with a 200/266/333/400MHz FSB. It features 3 DDR DIMM slots, 2 channels of Serial ATA 150MB/s data transfer rate with RAID function (0/1), onboard 10/100M PCI Fast Ethernet controller, onboard 6-Channel AC 97 CODEC, and hardware monitoring capabilities.

PDF

Document

BIOS Setup
3-7
3-3. Advanced BIOS Features
Hard Disk Boot Priority:
This item selects the hard disks booting priority. By pressing &lt;Enter&gt; key, you can enter its submenu
where the hard disks detected can be selected for the booting sequence to boot up system.
This item functions only when there is the option of [Hard Disk] in any one of the First/Second/Third
Boot Device items.
Virus Warning:
When set to [Enabled], the BIOS will monitor the boot sector and partition table of the hard disk drive. If
there is any attempt of writing to the boot sector or partition table of the hard disk drive, the BIOS will
halt the system and an error message will appear.
USB Flash Disk Type:
This item selects the type for your USB flash disk.
First Boot Device / Second Boot Device / Third Boot Device / Boot Other Device:
Select the drive to boot first, second and third in the [First Boot Device], [Second Boot Device], and
[Third Boot Device] items respectively. The BIOS will boot the operating system according to the
sequence of the drive selected. Set [Boot Other Device] to [Enabled] if you wish to boot from another
device other than these three items.
Swap Floppy Drive:
When set to [Enabled], and the system is booting from the floppy drive, the system will boot from drive B
instead of the regular drive A. There must be two floppy drives connected in the system to use this
function.
Boot Up Floppy Seek:
When set to [Enabled], the BIOS will check whether the floppy disk drive is installed or not.
User&acirc;s Manual
">

Hello! I am an AI chatbot specifically trained to assist you with the Abit KV7 Socket 462 User's manual. I have thoroughly reviewed the document and can help you locate the exact information you need or explain the content in clear and simple terms. Whether you’re looking for guidance on specific features, troubleshooting steps, or general usage, feel free to ask your questions. The more details you provide about your concerns or needs, the more accurately and effectively I can assist you!

Show related prompts

Assistant typing

Assistant is out of keyboard. Please, try again later.

Key features

Supports AMD Socket A processors
3 DDR DIMM slots
2 channels of Serial ATA 150MB/s
Onboard 10/100M PCI Fast Ethernet
Onboard 6-Channel AC 97 CODEC
Hardware monitoring

Frequently asked questions

This motherboard supports AMD-K7 Athlon/AthlonXP/Barton Socket A 200/266/333/400MHz FSB Processors.

This motherboard supports up to 3GB of un-buffered DDR 266 memory or 2GB of un-buffered DDR 333/400 memory.

The key features include support for AMD Socket A processors, 3 DDR DIMM slots, 2 channels of Serial ATA 150MB/s data transfer rate with RAID function (0/1), onboard 10/100M PCI Fast Ethernet controller, onboard 6-Channel AC 97 CODEC, and hardware monitoring capabilities.

This header allows you to select the S2K mode. Shorting pin-2 and pin-3 for "Strapping from Hardware" allows the CPU hardware to control the timing of the S2K bus for better system flexibility. The default setting is pin-1 and pin-2 shorted for "Strapping from boot ROM" which allows the internal boot ROM to control the timing of the S2K bus.