DIGITAL VIDEO CAMERA
User's Manual
WARNING
Attention:
To reduce the danger of electric shock, please do not open the case (or back cover) of camera; everything needed for user operation is on the surface of the camera; please seek help from a qualified professional for repair.
• Do not touch CCD or lens
• Do not use any unidentified power supply
• Avoid installation in unstable places
• Do not use camera in the following conditions,
• Suggested mounting height 8'-12'
• Do not point camera directly into light sources
Effective Pixels E:510(H)x492(V) C:5000(H)x582(V)
Signal system EIA/CCIR
Horizontal resolution 330TVL
Minimum illumination 0.05Lux/F2
Electronic shutter Auto:1/50(1/60)-1/100,000Sec
Gamma 0.45
Lens 3.6mm
Video output 1.0Vp-p, 75Ω
Power supply DV 12V±5%
Power consumption 200mA
Making a BNC Connection
Step 1: Strip away all of the cable and shielding so you have 1/2" of the center conductor exposed as shown in the picture.
Step 2: Then strip away the black outer jacket so allow any of the copper shielding to touch the center conductor.
Step 3: Insert the cable into the fitting and gently press the fitting onto the wire. Now just twist the fitting onto the wire while firmly pressing down until the fitting is firmly on the cable.
Installing a power wire pigtail
Step 1: At the camera location, take the power cable and strip away the outer sheathing to expose the inner two wires (black & red). Then strip away about 1/4" of the wires jacket to expose the copper wire. Do the same to the power connection as shown. Note: Do not strip or cut the power lead coming directly from the camera. You should strip the "pigtail" power cable which came with your kit. You should have one "pigtail" for each camera.
Step 2: Now take the red power cable lead and twist it together with the black & white lead from the power pigtail. Now take the black lead from the power cable and twist it together with the all black lead from the pigtail. Use the gray wire nuts the wires until they are firmly secured.
Connecting a Pre-made Cable
Connect this end to the camera.
The cables are labeled with a yellow wrap detailing the camera end before installing the cable so that you have the correct ends at the correct location.
Contact
EZWATCHPRO www.ezwatch-security-cameras.com
Phone/Fax
Toll Free 1-866-241-3400
International 001-801-4783980
Fax 1-801-295-2191
Main Office/Mailing Address
Automated Video Systems
1600 S. State Street
Salt Lake City, UT 84115
