2
Amcrest
Alarm Hub
Required
Quick Start Guide
Motion Sensor
Model: AL-PIRSEN1
We’d Love to Hear From You!
Not Included
Model: AL-KIT1-PP
We wanted to personally reach out and thank you for
purchasing from our Amazon store. Selling on Amazon
is what we do to support our family, and product
reviews are the lifeblood of our business. It would mean
the world to us if you could take one minute of your time
to help share the love by leaving us an honest review
using the link below:
www.amazon.com/ryp
Thank you again for being one of our amazing
customers!
Sincerely,
Amcrest Team
2
01
Product
Overview
What’s Included?
Motion Sensor
Specifications
Mounting Adhesive
Environment
Indoor
Max Detection Distance
26 feet
Max Detection Angle
110°
Operating Temperature
14°F ~ 113°F
Operating Humidity
0-95% RH
Battery Type
CR2450
Protocol
Bluetooth 5.0
LED Behavior
Please refer to the table below for details regarding the LED
behavior of the device.
Pin
Bracket (Optional)
*May include one or more depending
on the package purchased.
Behavior
To purchase additional sensors, visit us at amcrest.com
Overview
Battery Slot
Motion Sensor
Flashing Rapidly
Description
Sensor is pairing.
Solid (for 2 seconds)
Pairing successful
Flashing (3 times)
Pairing failed.
**Try repeating setup.
Flashing Rapidly
(after pairing)
Alarm has been triggered after
Steady Flash
Firmware upgrade is in progress.
LED Indicator
Pin Insert
3
4
Installing the Motion Sensor
Location tips:
• Install the motion sensor indoors on a
flat surface.
• The motion sensor should be placed 6 to
8 feet high to keep it from falling and out of
reach of children or pets.
1. Locate the Alarm Hub on
the main menu.
2. Tap on the “+” icon to
pair the sensor to the hub.
°
110
Pairing the Sensor
26 feet
• To detect smaller objects, it is
recommended to use one of the angled
sides of the bracket.
3. Follow the on-screen
prompts to finish setting up
the sensor.
Install Using the Mounting Bracket
The bracket offers two separate angles
for the sensor to face. Use the included
two-sided mounting adhesive to install
the sensor to the bracket.
1. Peel the other portion of the circular
mounting adhesive and adhere it to the
back of the bracket.
2. Peel the other portion of the circular
mounting adhesive and adhere it to the
back of the bracket.
3. Place another mounting adhesive to
the bracket to achieve the desired angle.
Note: Once the sensor has been
successfully paired, please begin
physical installation.
5
4. Peel the other portion of the mounting
adhesive and place the bracket onto a
flat surface.
6
Changing the Battery
The sensor uses a CR2450 cell type battery. The battery
typically lasts up to one year before it needs to be replaced.
1. Make sure that the alarm hub is disarmed before
changing the battery.
2. Use the wide portion of the pin to open the sensor from
the battery slot.
3. Slide the old battery out of the sensor and replace it with
a new battery.
4. Snap the top portion of the sensor into place and secure
it to the bottom portion of the sensor.
How can we help?
We are dedicated to providing the highest quality
support to our customers and are available 7 days
a week.
Online Quick Start Guide
amcrest.com/support
Need help?
Note: For more information
on this and other products
visit: amcrest.com/support
[email protected]
7
8
">
