TO PREVENT SERIOUS INJURY OR DEATH FROM
MOVING GARAGE DOORS OR GATES:
- DO NOT let children use the GOGOGATE product and app without adult supervision.
- ONLY Operate your GOGOGATE device when you are in clear view of your garage
or gate and you have verified that there are no objects obstructing the operation of
the door. ALWAYS wait for garage door or gate to be completely closed.
- NEVER operate the remote access feature of your GoGoGate without ensuring that
there is an adult physically present in front of the door or gate validating that it is safe
to start the remote operation of your device
WIRELESS DOOR SENSOR INSTALLATION GUIDE
Read instructions carefully before beginning
Please make sure your garage door is closed before you start installation.
The GoGogate product and our wireless door sensors are meant to be used with garage
door openers equiped with photo-eye safety sensors (manufactured after 1993). These
sensors are normally found at the bottom of your garage door and avoid accidental closing
of your garage door if an object or person is on the path of the door.
Step 1
Step 2
ID:1234
BACK VIEW
BACK VIEW
FRONT VIEW
Open the sensor’s batteries’ compartment
to include the provided AAA batteries (x2).
Place the batteries as per picture indications.
Finally, close the compartment.
SIDE VIEW
Note: write down and store in
a safe location the 4 digit code
located on the front of your sensor.
BACK VIEW
Make sure you place the sensor
with the “TOP” label facing
the garage door ceiling.
Place on the wall
with the double-sided
fastening strip.
Step 3
Attach your wireless sensors to your garage door as per drawing below.
PLACE THE SENSOR IN THE UPPER PART OF YOUR GARAGE WITH
RED LED LIGHT FACING DOWN. (LEFT OR RIGHT SIDE)
ID:1234
ID:1234
Place the sensors on the upper part of your garage door wall.
27 mm width
Main sensor’s features:
•
•
•
•
•
•
•
ID:1234
70 mm
Lenght
Remotely monitor if garage door is open or closed
Check garage door temperature in ºC/ºF
Receive real time alerts on your Smartphone
Easy to install tilt sensor with double sided tapes
Tilt switch broken when garage door opens.
Monitor sensor’s battery status for prompt replacement
Keep track of all garage door events in a built-in calendar of events
SPECS
Frequency
Range
Operating Temperature
24 mm
Height
GGG2-TWS-001
2.4 Ghz
50 m or 150 ft (open space)
Between -10ºC and 70ºC
Battery type
AAA (x2)
Battery life span
1.5 years
Packaging
Clamshell
Certification
CE - FCC
Regulatory notices
REMSOL has not approved any changes or modifications to this device by the user. Any changes or modifications could
void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
This device complies with FCCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC
radio frequency (RF) Exposure Guidelines. This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
•
•
•
•
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Still having issues. No problem.
Download our user manual in our website www.gogogate.com or contact us at: [email protected]
">
