801-174 3 Loop Bicycle Rack
Page
1
Rev. 10/10/03
IMPORTANT
PLEASE READ THESE INSTRUCTIONS BEFORE COMMENCING ASSEMBLY. All equipment must be installed in accordance with these instructions. Check your shipment against Bill of Lading and Parts list. Any missing or broken parts must be reported to your distributor within 10 days of receipt of your order. When properly installed and maintained, equipment will give many years of Safe,
Trouble-Free use. Periodically check for loose or broken parts. Loose bolts must be tightened and broken parts must be replaced as they can possibly create dangerous situations leading to unnecessary accidents. Resilient
Surfacing should be used under all playground equipment. Appropriate publications, available at no charge, from the Consumer Product Safety
Commission, include “A Handbook for Public Playground Safety”. You can receive your free copy by calling 1-301-504-7908.
1 CTN
PACKING LIST
803-103 Bike Rack unit 1 805-532
1 805-534
1
27 # Weight
HARDWARE BAG
Warning Label
SportsPlay Label
Maintenance Checklist
Class 70 1 CTN 1 TOTAL PCS
SportsPlay Equipment, Inc., 5642 Natural Bridge, St. Louis, MO 63120 (314) 389-4140
801-174 3 Loop Bicycle Rack
Page
2
Rev. 10/10/03
GENERAL USE/FALL ZONE & FOOTING RECOMMENDATIONS
Stationary & Portable equipment – Use/Fall zones should extend a minimum of 6 feet in all directions from the perimeter of the equipment ground space.
This area should be covered with the required amount of resilient safety surfacing material.
For some equipment – Use/Fall zones can overlap. See Consumer Product Safety
Commission Guidelines. Diameter and depth of footings illustrated are satisfactory in most applications for pipe sizes up to 2 3/8” diameter.
Varying soil & climatic conditions may require deeper and heavier footings in some areas. Check local building codes.
DETAIL-Permanent Installation
Upright:
GENERAL MAINTENANCE INSTRUCTIONS:
Check MONTHLY for loose bolts, damaged or broken parts. Tighten and/or replace immediately. On swings and any equipment that uses S-hooks and/or
Swing Hangers check the bearing surfaces for wear. Replace any parts that show a reduction of 25% from the original size.
ASSEMBLY AND INSTALLATION:
NOTE: All threaded ends of bolts protruding beyond nuts must be cut off and/or peened to eliminate sharp edges. No more than two threads should extend beyond face of nut. All washers, “T” nuts, and other fastener hardware used on round pipe or tubing must be hammered down to conform to the curved underlying surface to eliminate catch points.
DO NOT tighten nuts more than hand-tight until entire assembly is completed.
STEP #1: Dig footing hole 2 feet deep and 12 inches in diameter.
STEP #2: Brace Bicycle Rack in footing hole so that 24” of pipe will be under the intended level of surfacing.
STEP #3: Fill hole with cement. Be sure to dome cement for drainage.
NOTES: Attach warning label and Manufacturer’s Identification label to a clean surface. The labels should be attached in a location where they are clearly visible and legible and away from normal hand and foot placement areas. The labels must be replaced if they become illegible, destroyed or removed. Contact your SportsPlay distributor for replacements.
SportsPlay Equipment, Inc., 5642 Natural Bridge, St. Louis, MO 63120 (314) 389-4140
