Form No. 3466-655 Rev A
Flex-Force Power System®
1 AMP 60V MAX Battery
Charger
Model No. 86910—Serial No. 324000000 and Up
Original Instructions (EN)
*3466-655*
Introduction
This battery charger is intended to be used by residential homeowners.
This charger is designed to charge only Flex-Force 60V lithium-ion battery
packs. It is not designed to charge any other batteries. Using this product
for purposes other than its intended use could prove dangerous to you
and bystanders.
Read this information carefully to learn how to operate and maintain
your product properly and to avoid injury and product damage. You are
responsible for operating the product properly and safely.
Whenever you need service, genuine parts, or additional information,
contact an Authorized Service Dealer or distributor, or the tool
manufacturer’s Customer Service, and have the model and serial numbers
of your product ready. Figure 1 identifies the location of the model and
serial numbers on the product. Write the numbers in the space provided.
Important: With your mobile device, you can scan the QR code
on the serial number decal (if equipped) to access warranty, parts,
Operator’s Manuals, and other product information.
g400718
Figure 1
1. Model and serial number location.
Model No.
Serial No.
Original Instructions (EN)
Printed in China
All Rights Reserved
*3466-655*
Safety-Alert Symbol
The safety-alert symbol (Figure 2) shown in this manual and on the
machine identifies important safety messages that you must follow to
prevent accidents.
g000502
Figure 2
Safety-alert symbol
The safety-alert symbol appears above information that alerts you to
unsafe actions or situations and is followed by the word DANGER,
WARNING, or CAUTION.
DANGER indicates an imminently hazardous situation which, if not
avoided, will result in death or serious injury.
WARNING indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION indicates a potentially hazardous situation which, if not avoided,
may result in minor or moderate injury.
This manual uses two other words to highlight information. Important calls
attention to special mechanical information and Note emphasizes general
information worthy of special attention.
3
Safety
IMPORTANT SAFETY INSTRUCTIONS
1.
SAVE THESE INSTRUCTIONS—This manual contains important
safety and operating instructions for Flex-Force 60V lithium-ion
battery packs and Flex-Force 60V lithium-ion battery chargers.
2.
Before using the battery charger or battery pack, read all the
instructions and cautionary markings on the battery charger, battery
pack, and product using the battery pack.
3.
CAUTION—To reduce risk of injury, charge Flex-Force 60V
lithium-ion battery packs with Flex-Force 60V lithium-ion battery
chargers only. Other brands of battery packs may burst, causing
personal injury and damage.
4.
WARNING—Plugging the battery charger into an outlet that is not
220 to 240V can cause a fire or electric shock. Do not plug the
battery charger into an outlet other than 220 to 240V. For a different
style of connection, use an attachment plug adapter of the proper
configuration for the power outlet if needed.
I. Training
1.
Do not allow children or untrained people to operate or service this
device. Allow only people who are responsible, trained, familiar with
the instructions, and physically capable to operate or service the
device.
2.
Do not allow children to use or play with the battery pack or battery
charger; local regulations may restrict the age of the operator.
II. Preparation
1.
Use appliances only with specifically designated battery packs.
Using other types of battery packs may create a risk of injury and/or
fire.
2.
Do not use a damaged or modified battery pack or battery charger.
It may exhibit unpredictable behavior, resulting in fire, explosion,
or risk of injury.
3.
If the supply cord to the battery charger is damaged, contact an
Authorized Service Dealer to replace it.
III. Operation
1.
Do not use non-rechargeable batteries.
4
2.
Charge the battery pack with only the battery charger specified by
the tool manufacturer. A charger suitable for 1 type of battery pack
may create a risk of fire when used with another battery pack.
3.
Charge the battery pack in a well-ventilated area only.
4.
Follow all charging instructions and do not charge the battery pack
outside of the temperature range specified in the instructions.
Otherwise, you may damage the battery pack and increase the risk
of fire.
5.
Under abusive conditions, the battery pack may eject liquid; avoid
contact. If you accidently come into contact with the liquid, flush with
water. If the liquid contacts your eyes, seek medical help. Liquid
ejected from the battery pack may cause irritation or burns.
6.
Do not expose a battery pack or tool to fire or excessive temperature.
Exposure to fire or temperature above 130°C (265°F) may cause
explosion.
7.
CAUTION—A mistreated battery pack may present a risk of fire,
explosion, or chemical burn.
• Do not disassemble the battery pack.
• Replace the battery pack with a genuine Flex-Force battery pack
only; using another type of battery pack may cause a fire or risk
of injury.
• Keep battery packs out of the reach of children and in the original
packaging until you are ready to use them.
IV. Maintenance and Storage
1.
Do not allow children to clean or maintain the battery charger.
2.
When the battery pack is not in use, keep it away from metal objects
such as paper clips, coins, keys, nails, and screws that can make a
connection from 1 terminal to another. Shorting the battery terminals
may cause burns or a fire.
3.
Do not attempt to repair the battery pack or battery charger. Have
an Authorized Service Dealer or distributor perform service on the
battery pack or battery charger using identical replacement parts to
ensure that the product is safely maintained.
4.
Check with local codes for possible special battery disposal
instructions.
SAVE THESE INSTRUCTIONS
5
Product Overview
Specifications
Battery Charger
Model
86910
Type
60V MAX Lithium-Ion Battery Charger
Input
220 to 240V AC ~2.0A, 50-60Hz
Output
60V DC
1.0A MAX
Appropriate Temperature Ranges
Charge battery pack at
5°C (41°F) to 40°C (104°F)*
Use battery pack at
-30°C (-22°F) to 49°C (120°F)
Store battery pack/charger at
5°C (41°F) to 40°C (104°F)*
*Charging time will increase if you do not charge the battery within this
range. Store the tool, battery pack, and battery charger in an enclosed
clean, dry area.
Store the machine, battery pack, and battery charger in an enclosed
clean, dry area.
6
Operation
Charging the Battery Pack
Important: Charge the battery pack only in temperatures that are
within the appropriate range; refer to Specifications (page 6).
Note: At any time, press the battery-charge-indicator button on the
battery pack to display the current charge (LED indicators).
1.
Line up the cavity in the battery pack (Figure 3) with the tongue on
the charger.
g474968
Figure 3
1. Battery pack cavity
4. LED indicators (current charge)
2. Battery pack terminals
5. Handle
3. Battery-charge-indicator button
2.
Slide the charger into the battery pack until it is fully seated (Figure 3).
3.
To remove the battery pack, slide the charger backward out of the
battery pack.
7
4.
Refer to the following table to interpret the LED indicator light on
the battery charger.
Indicator
light
Indicates
Off
No battery pack inserted
Green
blinking
Battery pack is charging
Green
Battery pack is charged
Red
Battery pack and/or battery charger is over or under the appropriate
temperature range
Red blinking
Battery pack charging fault*
*Refer to Troubleshooting (page 10) for more information.
Important: The battery can be left on the charger for short periods
between uses.
If the battery will not be used for longer periods, remove the battery
from the charger; refer to Storage (page 9).
8
Maintenance
Maintenance and servicing are not required under normal conditions.
When you clean the surface of the equipment, wipe it only with a dry cloth.
Do not disassemble the equipment; if it is damaged, contact your
Authorized Service Dealer or distributor.
Storage
Important: Store the charger only in temperatures that are within
the appropriate range; refer to Specifications (page 6).
Important: If you are storing the charger for the off-season, ensure
that it is unplugged and that there are no batteries installed.
• Disconnect the product from the power supply (i.e., remove the battery
pack) and check for damage after use.
• Do not store the charger with the battery pack installed.
• Clean all foreign material from the product.
• Do not store any machine with the battery pack installed.
• When not in use, store the tool, battery pack, and battery charger out
of the reach of children.
• Keep the tool, battery pack, and battery charger away from corrosive
agents, such as garden chemicals and de-icing salts.
• To reduce the risk of serious personal injury, do not store the battery
pack outside or in vehicles.
• Store the tool, battery pack, and battery charger in an enclosed clean,
dry area.
9
Troubleshooting
Perform only the steps described in these instructions. All further
inspection, maintenance, and repair work must be performed by an
authorized service center or a similarly qualified specialist if you cannot
solve the problem yourself.
Problem
The battery charger is not
working.
The LED indicator light
on the battery charger is
blinking red.
Possible Cause
Corrective Action
1. The battery charger
is over or under
the appropriate
temperature range.
1. Unplug the battery
charger and move it to
a place where it is dry
and the temperature
is between 5°C (41°F)
and 40°C (104°F).
2. The outlet that the
battery charger is
plugged into does not
have power.
2. Contact your licensed
electrician to repair the
outlet.
1. There is an error in
the communication
between the battery
pack and the charger.
1. Remove the battery
pack from the battery
charger, unplug the
battery charger from
the outlet, and wait
10 seconds. Plug the
battery charger into the
outlet again and place
the battery pack on the
battery charger. If the
LED indicator light on
the battery charger is
still blinking red, repeat
this procedure again.
If the LED indicator
light on the battery
charger is still blinking
red after 2 attempts,
properly dispose of the
battery pack at a battery
recycling facility.
2. The battery pack is
weak.
2. Contact your authorized
service dealer or
distributor if the battery
is in warranty, or
properly dispose of
the battery pack at a
battery recycling facility.
10
Notes:
">
