Leaf4Go 5 Inch Gutter Cover Installation Guide

INSTALLATION GUIDE
Left to Right: Work left to right as viewed from the ground.
Lay Leaf4go gutter cover completely flat over your existing
gutters with the front edge of the guard lined up with the top
front edge of the gutter and the back edge lying on the dripedge.
Rear Edge
Front Lip
Use screw holes along the front and back edge of Leaf4go
gutter cover to zip screw the panel - 3 screws (1, 2 & 3) to
the front lip of the gutter and 2 screws (4 & 5) through the
rear edge. DIAGRAM 2: This shows where to screw along
the back edge of Leaf4go gutter cover to secure your gutter
guards in place.
FOR INSIDE CORNERS: For 5" Leaf4go gutter cover,
measure 5 inches in from the end of the piece and put a mark
on the front edge of the guard. From the mark, cut a 45
degree angle from the front edge of Leaf4go gutter cover to
the back drip-edge. Trim the sharp corner of the front edge,
about 1 inch in. Repeat for the other piece, excluding
trimming the corner. Place this piece on top of the other,
lining up the holes to allow for screws. Zip screw to gutter
and you now have a seamless connection. (For 6" Leaf4go
gutter cover, measure inches.)
FOR OUTSIDE CORNERS: For 5" Leaf4go gutter cover,
measure 5 inches in from the end of the piece and put a
mark on the back drip-edge of the guard. From the mark, cut
a 45 degree angle from the back drip-edge of Leaf4go
gutter cover to the front edge. Trim the sharp corner of back
drip-edge about 1 inch in. Repeat for the other piece,
excluding trimming the corner. Place this piece on top of the
other, lining up the holes to allow for screws. Zip screw to
BELLA
POWELLconnection. (For 6"
gutter and you now have
a seamless
Leaf4go gutter cover, measure 6 inches.)
">